Time to Positivity of Bacteria Cultures in Peritoneal Dialysis Fluid: Evaluation of Different Laboratory Techniques

Patients with chronic kidney disease on peritoneal dialysis (PD) are susceptible to infections, with peritonitis being the primary cause of dropout. Peritoneal fluid culture is one of the essential elements for proper diagnosis and peritonitis treatment. The aim of this study was to compare the time required to obtain a positive culture using different laboratory methods. An in vitro cross-sectional study was conducted comparing different techniques for preparation and culture of bacteria in peritoneal fluid. The research was carried out with 21 sterile dialysis bags and 21 PD bags containing peritoneal fluid drained from patients without peritonitis. Fluids from the 42 PD bags were contaminated by injecting a coagulase-negative Staphylococcus suspension and then prepared for culture using 4 distinct techniques: A - direct culture; B - post-centrifugation culture; C - direct culture after 4 h sedimentation; and D - culture after 4 h sedimentation and centrifugation. This was followed by seeding. In the 21 contaminated sterile bags, mean times to obtain a positive culture with techniques D (19.6 h ± 2.6) and C (19.1 h ± 2.3) were longer than with technique A (15.8 h ± 3.0; p < 0.01), but not statistically different from group B (19.0 h ± 3.2). The same occurred in the 21 bags drained from patients, with mean times for techniques D (14.0 h ± 1.9) and C (14.5 h ± 1.7) being longer than technique A (12.22 h ± 1.94; p < 0.05) but not statistically different from technique B (13.2 h ± 1.3). The sedimentation and centrifugation steps seem to be unnecessary and may delay antibiotic sensitivity test results by approximately 8 hours.