Related Experiment Video

Updated: Mar 2, 2026

Optimize Flue Gas Settings to Promote Microalgae Growth in Photobioreactors via Computer Simulations
14:33

Optimize Flue Gas Settings to Promote Microalgae Growth in Photobioreactors via Computer Simulations

Published on: October 1, 2013

15.0K

Determination of volumetric gas-liquid mass transfer coefficient of carbon monoxide in a batch cultivation system

Nulee Jang1, Muhammad Yasin2, Shinyoung Park1

  • 1School of Earth Sciences and Environmental Engineering, Gwangju Institute of Science and Technology (GIST), Gwangju 61005, Republic of Korea.

Bioresource Technology
|May 23, 2017
PubMed

Keywords:
Batch cultivationCarbon monoxideEubacterium limosum KIST612Gas–liquid mass transferKinetic simulation

More Related Videos

Medium Preparation for the Cultivation of Microorganisms under Strictly Anaerobic/Anoxic Conditions06:17

Medium Preparation for the Cultivation of Microorganisms under Strictly Anaerobic/Anoxic Conditions

Published on: August 15, 2019

30.1K
Microalgae Cultivation and Biomass Quantification in a Bench-Scale Photobioreactor with Corrosive Flue Gases08:41

Microalgae Cultivation and Biomass Quantification in a Bench-Scale Photobioreactor with Corrosive Flue Gases

Published on: December 19, 2019

10.9K

Related Concept Videos

Turbulent Flow: Problem Solving01:09

Turbulent Flow: Problem Solving

Carbonation is a process used to dissolve carbon dioxide gas in a liquid, commonly used in the production of carbonated beverages. Achieving efficient carbonation requires careful control of temperature, pressure, and flow conditions. By adjusting these parameters, carbonation efficiency can be maximized, producing a higher concentration of CO2 in the liquid.
Temperature is a key factor in CO2 solubility. In this case, the CO2 gas and the liquid are cooled to 20°C. Lower temperatures enhance...
469
Chemical Stoichiometry and Gases: Using Ideal Gas Law to Determine Moles03:12

Chemical Stoichiometry and Gases: Using Ideal Gas Law to Determine Moles

Chemical stoichiometry describes the quantitative relationships between reactants and products in chemical reactions.
30.3K
Distillation: Vapor–Liquid Equilibria01:01

Distillation: Vapor–Liquid Equilibria

Distillation is a separation technique that takes advantage of the boiling point properties of disparate elements in a mixture. To perform distillation, we begin by heating a miscible mixture of two liquids with a significant difference in boiling points (at least 20°C). As the solution heats up and reaches the bubble point of the more volatile component, some molecules of the more volatile component transition into the gas phase and travel upward into the condenser, which is a glass tube...
4.8K
Factors Affecting Activity Coefficient01:17

Factors Affecting Activity Coefficient

The extended Debye-Hückel equation indicates that the activity coefficient of an ion in an aqueous solution at 25°C depends on three partially interdependent properties: the ionic strength of the solution, the charge of the ion, and the ion size. 
The activity coefficient value for an ion is close to one when the solution has almost zero ionic strength, i.e., when the solution shows close to ideal behavior. As the ionic strength of the solution increases from 0 to 0.1 mol/L, a...
1.7K
Determination of Michaelis Constant and Maximum Elimination Rate01:20

Determination of Michaelis Constant and Maximum Elimination Rate

The Michaelis constant (KM) and the theoretical maximum process rate (Vmax) are vital parameters in the Michaelis-Menten equation, central to many biochemical reactions. They provide essential insights into enzyme kinetics and drug metabolism.
These parameters can be estimated by analyzing plasma concentration data post-drug administration. A notable example of this application is phenytoin, a drug with capacity-limited kinetics. It's recommended that phenytoin should be administered at two...
579
One-Compartment Open Model for IV Bolus Administration: Estimation of Elimination Rate Constant, Half-Life and Volume of Distribution01:09

One-Compartment Open Model for IV Bolus Administration: Estimation of Elimination Rate Constant, Half-Life and Volume of Distribution

The one-compartment open model is a simplified approach used in pharmacokinetics to understand the distribution and elimination of a drug administered through an intravenous bolus. This model assumes rapid drug dispersal throughout the body and elimination using a first-order process. Key pharmacokinetic parameters, such as the elimination rate constant (k), half-life (t1/2), and the apparent volume of distribution (Vd), can be estimated from this model. The elimination rate is calculated...
1.0K