Evaluation of the starch-based flocculants on flocculation of hairwork wastewater

China is the world's largest producer of wigs, and the manufacturing generates large quantities of hairwork effluents. Coagulation/flocculation is an important step in the water treatment process. In this study, two versions of starch-based flocculants were successfully prepared through etherification and graft copolymerization, respectively. Starch-3-chloro-2-hydroxypropyl triethyl ammonium chloride (St-CTA-DQ) and starch-graft-poly[(2-methacryloyloxyethyl) trimethyl ammonium chloride] (St-g-PDMC-DQ) both contain strongly cationic quaternary ammonium salt groups, but have differing cationic contents, specifically, the degree of substitution (DS) and grafting ratio (G). Furthermore, the additional functional groups were distributed on different chain sites (the starch backbone for St-CTA-DQ, and the branch chains for St-g-PDMC-DQ). These two flocculants demonstrated superior efficiency for turbidity and UV₂₅₄ removal in hairwork wastewater as well as better floc properties compared to polyaluminum chloride. The effects of pH, flocculant dose, and cationic group contents (DS and G) were systematically investigated. Consequently, it was determined that a higher cationic content in both the flocculants led to better flocculation performance as well as increased removal rates of both turbidity and UV₂₅₄. This was primarily due to improved charge neutralization, which highlighted the preference towards a lower optimal dose. In addition, flocculation performance worsened as the pH level increased. Overall, St-g-PDMC-DQ exhibited similar flocculation performance to St-CTA-DQ. However, the wastewater treated by St-g-PDMC-DQ showed lower residual turbidity than when treated by St-CTA-DQ. This was attributed to the distinct branch chain architecture of St-g-PDMC-DQ, which was beneficial for coagulating the uneasily flocculated contaminants in water, such as smaller-sized colloids and water-soluble organic substances. Flocculant structural factors, specifically charge properties and chain architecture, heavily affected the final flocculation performance.