Inactivation of Bacillus Spores in Wash Waters Using Dilute Chlorine Bleach Solutions at Different Temperatures and
Abstract:
Inactivation of Bacillus globigii spores in wash water was studied to simulate chlorine inactivation of Bacillus anthracis spores in water generated during biological cleanups. Eight waters were studied, with six containing detergent. Chlorine levels were approximately 3000 mg/L. Results across different waters showed decreasing inactivation with increasing pH. Inactivation did not appear to be influenced by chemical oxygen demand, suspended solids, turbidity, or dissolved solids. Inactivation efficacy was expressed as the time calculated to yield 6 log10 inactivation at 3000 mg NaOCl/L. This time ranged from 5 to 51 minutes at ~21 °C and from 11 to 209 minutes at ~5 °C. For one wash water, inactivation was conducted when there was no pH adjustment, and when the pH was buffered at 7 and 8. Inactivation in these buffered waters was rapid, but inactivation decreased sharply at a pH above ~9.3.
More Related Videos
Related Concept Videos
Methods of Sterilization I: Physical Methods
Steam sterilization uses non-toxic, low-cost moist heat in the form of saturated steam under pressure, which is fast, microbicidal, and sporicidal, and quickly warms and penetrates fabrics. Autoclaves, or steam sterilizers, expose each item to direct steam contact for a predetermined time at the necessary...
Physical Methods for Controlling Microbial Growth: Temperature
Methods of Sterilization II: Chemical Methods
Using chemical sterilization rather than heat to clean out equipment is recommended. It eradicates and removes all bacteria,...
Methods for Controlling Microbial Growth
Chemical Agents for Microbial Control
Physical Methods for Controlling Microbial Growth: Radiation and Filtration


