Do big numbers assure high-quality of data?

In engineering applications, the representation of the numerical value is critical. Presenting or reporting the answer is one of the essential parts of engineering practices. Numerical calculations are performed using handheld calculators or computers since numerically accurate answers are always preferred.
The solution to a problem is obtained using different methods. While manually solving algebraic symbols is one of the most common methods, the graphical method is often preferred. Computers...

The way a set of data is measured is called its level of measurement. Correct statistical procedures depend on a researcher being familiar with levels of measurement. For analysis, data are classified into four levels of measurement—nominal, ordinal, interval, and ratio.
A set of data measured using the ratio scale takes care of the ratio problem and provides complete information. Ratio scale data are like interval scale data, except they have a zero point and ratios can be calculated....

Data that are countable or measurable in specific units are called numerical or quantitative data. Quantitative data are always numbers. Quantitative data are the result of counting or measuring the attributes of a population. Amount of money, pulse rate, weight, number of people living in a town, and number of students who opt for statistics are examples of quantitative data.
Quantitative data may be either discrete or continuous. All quantitative data that take on only specific numerical...

When we take repeated measurements on the same or replicated samples, we will observe inconsistencies in the magnitude. These inconsistencies are called errors. To categorize and characterize these results and their errors, the researcher can use statistical analysis to determine the quality of the measurements and/or suitability of the methods.
One of the most commonly used statistical quantifiers is the mean, which is the ratio between the sum of the numerical values of all results and the...

All the digits in a measurement, including the uncertain last digit, are called significant figures or significant digits. Note that zero may be a measured value; for example, if a scale that shows weight to the nearest pound reads “140,” then the 1 (hundreds), 4 (tens), and 0 (ones) are all significant (measured) values.

When one or more data points appear far from the rest of the data, there is a need to determine whether they are outliers and whether they should be eliminated from the data set to ensure an accurate representation of the measured value. In many cases, outliers arise from gross errors (or human errors) and do not accurately reflect the underlying phenomenon. In some cases, however, these apparent outliers reflect true phenomenological differences. In these cases, we can use statistical methods...