Influence of B₁-Inhomogeneity on Pharmacokinetic Modeling of Dynamic Contrast-Enhanced MRI: A Simulation Study

To simulate the B₁-inhomogeneity-induced variation of pharmacokinetic parameters on dynamic contrast-enhanced magnetic resonance imaging (DCE-MRI).

B₁-inhomogeneity-induced flip angle (FA) variation was estimated in a phantom study. Monte Carlo simulation was performed to assess the FA-deviation-induced measurement error of the pre-contrast R₁, contrast-enhancement ratio, Gd-concentration, and two-compartment pharmacokinetic parameters (K^trans, v_e, and v_p).

B₁-inhomogeneity resulted in -23-5% fluctuations (95% confidence interval [CI] of % error) of FA. The 95% CIs of FA-dependent % errors in the gray matter and blood were as follows: -16.7-61.8% and -16.7-61.8% for the pre-contrast R₁, -1.0-0.3% and -5.2-1.3% for the contrast-enhancement ratio, and -14.2-58.1% and -14.1-57.8% for the Gd-concentration, respectively. These resulted in -43.1-48.4% error for K^trans, -32.3-48.6% error for the v_e, and -43.2-48.6% error for v_p. The pre-contrast R₁ was more vulnerable to FA error than the contrast-enhancement ratio, and was therefore a significant cause of the Gd-concentration error. For example, a -10% FA error led to a 23.6% deviation in the pre-contrast R₁, -0.4% in the contrast-enhancement ratio, and 23.6% in the Gd-concentration. In a simulated condition with a 3% FA error in a target lesion and a -10% FA error in a feeding vessel, the % errors of the pharmacokinetic parameters were -23.7% for K^trans, -23.7% for v_e, and -23.7% for v_p.

Even a small degree of B₁-inhomogeneity can cause a significant error in the measurement of pharmacokinetic parameters on DCE-MRI, while the vulnerability of the pre-contrast R₁ calculations to FA deviations is a significant cause of the miscalculation.