The potency of a drug is the measure of its ability to produce a biological response and can be compared by looking at the half-maximum effective concentration or EC50 values of different drugs. A lower EC50 value indicates higher potency of the drug. In the dose–response curve of two antihypertensive drugs, candesartan and irbesartan, a significant difference is observed in their EC50 values. A lower EC50 value for candesartan indicates that it is more potent than irbesartan, as it...

A drug’s dosage and pharmacokinetic properties determine how quickly it acts, how intense its effects are, and how long it lasts. Higher doses increase drug concentration at receptor sites, producing a hyperbolic curve when pharmacologic response is plotted against drug dose. Converting this scale to a log-linear format results in a sigmoidal curve, better representing dose–response relationships.For drugs following a one-compartment model, the pharmacologic response is directly...

Drug response models describe how pharmacological agents interact with biological systems to produce measurable effects. Baseline responses are inherent physiological activities without a drug significantly influencing the observed pharmacological outcomes. Depending on the drug response model employed, these baseline responses may combine with the drug's effect in either an additive or proportional manner.Additive Drug Response ModelIn the additive model, the drug effect is independent of the...

Pharmacodynamics explores the relationship between drug concentration and its effect. In a quantal response drug, the duration of action better correlates with drug concentration, while for graded effect drugs, the intensity of response is more relevant. This intensity depends on the dose, drug removal rate, and the region of the concentration–response curve.The concentration–response curve can be divided into three regions. Region 3 (80–100% maximum response) demonstrates...

The empirical approach to drug therapy optimization relies on correlating pharmacological response with administered dosage. Such an approach can be costly, time-consuming, and often yields poor correlation due to variables like formulation factors and drug elimination characteristics. A more precise approach correlates response with plasma drug concentration or the amount of drug in the body, rather than dosage. This is achieved through pharmacokinetic-pharmacodynamic (PK/PD) modeling, which...

The log-linear model is a pharmacological framework used to describe the relationship between drug concentration and its effect. This model is particularly relevant when the observed effects range between 20% and 80% of the drug’s maximum effect (Emax), where a near-linear relationship is observed between the log of drug concentration and the measured effect. However, the log-linear model does not predict the maximum possible effect (Emax) or the effect at zero drug concentration,...