Related Experiment Video
Updated: Feb 25, 2026

Challenges in Rheological Characterization of Highly Concentrated Suspensions — A Case Study for Screen-printing Silver Pastes
Published on: April 10, 2017
Localized stress fluctuations drive shear thickening in dense suspensions
Vikram Rathee1,2, Daniel L Blair1,2, Jeffrey S Urbach3,2
1Department of Physics, Georgetown University, Washington, DC 20057.
Abstract:
Dense particulate suspensions exhibit a dramatic increase in average viscosity above a critical, material-dependent shear stress. This thickening changes from continuous to discontinuous as the concentration is increased. Using direct measurements of spatially resolved surface stresses in the continuous thickening regime, we report the existence of clearly defined dynamic localized regions of substantially increased stress that appear intermittently at stresses above the critical stress. With increasing applied stress, these regions occupy an increasing fraction of the system, and the increase accounts quantitatively for the observed shear thickening. The regions represent high-viscosity fluid phases, with a size determined by the distance between the shearing surfaces and a viscosity that is nearly independent of shear rate but that increases rapidly with concentration. Thus, we find that continuous shear thickening arises from increasingly frequent localized discontinuous transitions between distinct fluid phases with widely differing viscosities.
More Related Videos
Related Concept Videos
Navier–Stokes Equations
Newtonian Fluid: Problem Solving
A velocity gradient forms within the fluid when a Newtonian fluid is placed between two parallel plates, with...
Stress: General Loading Conditions
The shearing force, possessing potential directionality within the plane of the section, is simplified into two component forces running parallel to the x and y axes....
Elastic Strain Energy for Shearing Stresses
Problem Solving on Stress and Strain
Shearing Stress
The average shearing stress can be calculated by dividing the shear by the area of the cross-section.

