The mechanical effects of cup inclination and anteversion angle on the bearing surface

Regarding the cup setting in total hip arthroplasty, range of motion and prevention of dislocation are important. From past reports, the wear of the bearing surface may affect long-term results. This study evaluated the stress applied to the bearing surface by the combined use of the three-dimensional rigid spring model and the finite-element analysis.

For contact pressure distribution of the bearing surface, interference analysis was performed using a three-dimensional rigid body spring model. Furthermore, stress was applied to the inner surface of the cup installed in the bone so that the same stress distribution obtained from the interference analysis was achieved. The finite-element analysis was then performed at each condition, which changed the inclination and anteversion angles of the cup to examine the relationship of maximum equivalent stress.

The maximum equivalent stresses on the bearing surface under the condition with fixation of an anteversion angle of 0° were 0.78, 0.85, and 1.15 MPa at inclination angles of 25°, 40°, and 55°, respectively. The stress value at 55° was approximately 1.5 times greater than that at 25°. The maximum equivalent stresses on the bearing surface under the condition with fixation of an inclination angle of 40° were 0.85, 0.9, and 1.02 MPa at anteversion angles of 0°, 15°, and 30°, respectively. The stress value at 30° was approximately 1.2 times greater than that at 0°. This study suggests that large inclination and anteversion angles may enhance the stress on the bearing surface and affect long-term results.