Related Experiment Video
Updated: Feb 24, 2026
Force System with Vertical V-Bends: A 3D In Vitro Assessment of Elastic and Rigid Rectangular Archwires
Published on: July 24, 2018
Effect of esthetic coating on surface roughness of orthodontic archwires
Seyed Mohammad Mousavi1, Milad Shamohammadi1, Zahra Rastegaar2
1Department of orthodontics, school of dentistry, Ahvaz Jundishapur university of medical science, Ahvaz, Iran.
Background And Aim:
Esthetic wires are commonly used in orthodontic treatments. Surface roughness is an important factor in the friction and bacterial adhesion in these wires. Surface roughness of esthetic wires has not been assessed, except in a few recent (mostly qualitative esthetics) studies. The aim of this study was to quantitatively compare the surface roughness of 4 coated esthetic wires with that of a conventional orthodontic wire.
Materials And Methods:
In this in vitro trial, 25 coated and uncoated orthodontic archwires were studied, including: NiTi Memory wire (American Orthodontics, USA) as a control group; Orthocosmetic Elastinol (Ortho Organizers, USA); Perfect (Hubit, Korea); Imagination (Gestenco, Sweden); EverWhite (American Orthodontics, USA). All were .016×.022" rectangular maxillary wires. Fifteen millimeters of wire was cut off at the posterior end and a surface area of 2000×2000nm was probed using a Scanning Probe Microscope (DS95-50E/DME, Denmark) to determine the surface roughness values. The roughness parameters of Sa, Sdq, Sv and Sy were measured and statistically compared by Kruskal-Wallis and Mann-Whitney U tests.
Results:
The average range of the 4 parameters was the highest for the uncoated Ni-Ti Memory wire (control group) while the Perfect coated wire showed the lowest values. The differences were significant for parameters Sa and Sy (P<0.02 and P<0.023) and non-significant for Sv and Sdq. Significant differences existed between uncoated and coated wires regarding Sa and Sy values (P<0.01), being higher for the uncoated wires.
Conclusion:
Taking into account the study limitations, the surface roughness values of NiTi uncoated archwires were significantly higher than those of the coated wires.
