Related Experiment Video
Updated: Feb 24, 2026

A Uniaxial Compression Experiment with CO2-Bearing Coal Using a Visualized and Constant-Volume Gas-Solid Coupling Test System
Published on: June 12, 2019
Fractal evolution under in situ pressure and sorption conditions for coal and shale
Rui Zhang1, Shimin Liu2, Yang Wang3,4
1Department of Energy and Mineral Engineering, G3 Center and Energy Institute, The Pennsylvania State University, University Park, PA, 16802, USA.
Abstract:
Coalbed methane (CBM) and shale gas become two most important unconventional natural gas resources in US. The fractal dimension, known as the degree of self-similarity or irregularity, is an important parameter to quantitatively characterize gas storage capacity and gas transport properties in pores of rock matrix. In this study, two coal and two shale samples were evaluated to estimate fractal dimensions using combined small angle X-ray scattering (SAXS), small angle neutron scattering (SANS) and low-pressure N2 adsorption techniques. The results show that surface fractal dimension D s of inaccessible pores is greater than that for total pores based on SANS results for all four tested samples. D s of accessible pores estimated by N2 desorption is greater than that for N2 adsorption for each linear section of each tested sample. Based on in situ SANS results, D s slightly decreases with increasing argon injecting pressure for San Juan coal. D s decreases with increasing methane and CO2 injecting pressure for samples with high D s . However, D s significantly increases when CO2 became liquid phase for samples with low D s . Furthermore, D s almost didn't change after methane and argon penetrations for all these samples except Marcellus outcrop shale.
More Related Videos
07:23Experimental Study of the Relationship Between Particle Size and Methane Sorption Capacity in Shale
Published on: August 2, 2018
13:11Using Flexible Gold-Titanium Reaction Cells to Simulate Pressure-Dependent Microbial Activity in the Context of Subsurface Biomining
Published on: October 5, 2019
Related Concept Videos
Phase Diagrams
Porosity and Absorption of Aggregate
When all pores in an aggregate are filled with water, the aggregate is considered saturated and surface-dry. If left in dry air, water will evaporate until the...
Entropy and Solvation