Related Experiment Video
Updated: Feb 23, 2026

Modeling the Size Spectrum for Macroinvertebrates and Fishes in Stream Ecosystems
Published on: July 30, 2019
Correcting for unequal catchability in sex ratio and population size estimates
Donald T McKnight1, Day B Ligon1
1Department of Biology, Missouri State University, Springfield, Missouri, United States of America.
Abstract:
Wildlife populations often exhibit unequal catchability between subgroups such as males and females. This heterogeneity of capture probabilities can bias both population size and sex ratio estimates. Several authors have suggested that this problem can be overcome by treating males and females as separate populations and calculating a population estimate for each of them. However, this suggestion has received little testing, and many researchers do not implement it. Therefore, we used two simulations to test the utility of this method. One simulated a closed population, while the other simulated an open population and used the robust design to calculate population sizes. We tested both simulations with multiple levels of heterogeneity, and we used a third simulation to test several methods for detecting heterogeneity of capture probabilities. We found that treating males and females as separate populations produced more accurate population and sex ratio estimates. The benefits of this method were particularly pronounced for sex ratio estimates. When males and females were included as a single population, the sex ratio estimates became inaccurate when even slight heterogeneity was present, but when males and females were treated separately, the estimates were accurate even when large biases were present. Nevertheless, treating males and females separately reduced precision, and this method may not be appropriate when capture and recapture rates are low. None of the methods for detecting heterogeneity were robust, and we do not recommend that researchers rely on them. Rather, we suggest separating populations by sex, age, or other subgroups whenever sample sizes permit.
Related Concept Videos
Testing a Claim about Population Proportion
There are two methods of testing a claim about a population proportion: (1) Using the sample proportion from the data where a binomial distribution is approximated to the normal distribution and (2) Using the binomial probabilities calculated from the data.
The first method uses normal distribution as an approximation to the binomial distribution. The requirements are as follows: sample size is large...
The Ratio of X Chromosome to Autosomes
Normal male Drosophila has a ratio of one X chromosome to two sets of autosomes. In contrast, normal female...
What are Populations and Communities?
Contaminants and Errors
Another key consideration is determining the appropriate number of samples required to...
Testing a Claim about Mean: Known Population SD
Estimating a population mean requires the samples to be distributed normally. The data should be collected from the randomly selected samples having no sampling bias. The sample size needed to be higher than 30, and most importantly, the population standard deviation should be already known.
In most realistic situations, the population standard deviation is often unknown, but in rare circumstances, when it...
Distributions to Estimate Population Parameter

