Related Experiment Video

Updated: Feb 23, 2026

Mechanical Manipulation of Neurons to Control Axonal Development
10:02

Mechanical Manipulation of Neurons to Control Axonal Development

Published on: April 10, 2011

10.9K

Revolving Vernier Mechanism Controls Size of Linear Homomultimer

Takeo Uchida1, Keita Abe1, Yuma Endo1

  • 1BIOMOD 2015, Team Sendai, Tohoku University, Aoba-yama, Sendai, Miyagi, 980-8579, Japan.

Small (Weinheim an Der Bergstrasse, Germany)
|September 13, 2017
PubMed

Keywords:
DNA nanotechnologyDNA origamiVernier mechanismlinear homomultimerself-assembly

More Related Videos

Gain-compensation Methodology for a Sinusoidal Scan of a Galvanometer Mirror in Proportional-Integral-Differential Control Using Pre-emphasis Techniques09:01

Gain-compensation Methodology for a Sinusoidal Scan of a Galvanometer Mirror in Proportional-Integral-Differential Control Using Pre-emphasis Techniques

Published on: April 4, 2017

9.1K
Measurement of Extracellular Ion Fluxes Using the Ion-selective Self-referencing Microelectrode Technique09:18

Measurement of Extracellular Ion Fluxes Using the Ion-selective Self-referencing Microelectrode Technique

Published on: May 3, 2015

14.5K

Related Concept Videos

Relative Motion Analysis - Acceleration01:10

Relative Motion Analysis - Acceleration

A slider-crank mechanism converts rotational motion from the crank into linear motion of the slider or vice versa. This mechanism consists of three main parts: the crank, the connecting rod, and the slider. The movement of the slider-crank is an example of general plane motion as the fluctuating angle between the crank and the connecting rod. Consider a segment AB where point A is at the end of the slider and point B is on the diametrically opposite end to point A, on a crack. The variance in...
951
Potentiometer01:30

Potentiometer

Voltage and current measurements using a standard voltmeter and ammeter alter the circuit being measured either by drawing or resisting the current flow, which introduces uncertainties in the measurements. Null measurements balance the voltages so that no current flows through the measuring device and, therefore, no alterations occur in the measured circuit.
Suppose the emf of a battery needs to be measured. If the battery is directly connected to a standard voltmeter, the measured quantity is...
2.2K
Relating Angular And Linear Quantities - II01:05

Relating Angular And Linear Quantities - II

In the case of circular motion, the linear tangential speed of a particle at a radius from the axis of rotation is related to the angular velocity by the relation:
6.7K
Mechanism of Ciliary Motion01:05

Mechanism of Ciliary Motion

The ciliary structures were first seen in 1647 by Antonie Leeuwenhoek while observing the protozoans. In lower organisms, these appendages are responsible for cell movement, while in higher organisms, these appendages help in the movement of the extracellular fluids within the body cavities.
The cilia are made up of microtubules in a 9+2 arrangement, with nine microtubule doublet ring bundles, surrounding a pair of central singlet microtubule bundles. The doublet microtubule bundles are...
5.4K
Relating Angular And Linear Quantities - I01:09

Relating Angular And Linear Quantities - I

If the rotational definitions are compared with the definitions of linear kinematic variables from motion along a straight line and motion in two and three dimensions, we can observe a mapping of the linear variables to the rotational ones.
When comparing the linear and rotational variables individually, the linear variable of position has physical units of meters, whereas the angular position variable has dimensionless units of radians, as it is the ratio of two lengths. The linear velocity...
8.6K
Circular Shaft - Stresses in Linear Range01:13

Circular Shaft - Stresses in Linear Range

Consider a scenario where a circular shaft is subject to torque that remains within the boundaries of Hooke's Law, avoiding any permanent deformation. So, the formula for shearing strain is revisited. This formula is multiplied by the modulus of rigidity, and then Hooke's Law for the shearing stress and strain is applied. As a result, the equation for shearing stress in a shaft can be derived.
769