Biomechanical analysis of lumbar decompression surgery in relation to degenerative changes in the lumbar spine -...

There are no studies about the biomechanical analysis of lumbar decompression surgery in relation to degenerative changes of the lumbar spine. Therefore, the purpose of this study was to compare, by using finite element (FE) analysis, the biomechanical changes of the lumbar spine in terms of annulus stress and nucleus pressure after two different kinds of lumbar decompression surgery in relation to disc degenerative changes.

The validated intact and degenerated FE models (L2-5) were used in this study. In these two models, two different decompression surgical scenarios at L3-4, including conventional laminectomy (ConLa) and the spinous process osteotomy (SpinO), were simulated. Therefore, a total of six models were simulated. Under preloading, 7.5 Nm moments of flexion, extension, lateral bending, and torsion were imposed. In each model, the maximal von Mises stress on the annulus fibrosus and nucleus pressure at the index segment (L3-4) and adjacent segments (L2-3 and L4-5) were analyzed.

The ConLa model and disc degeneration model demonstrated a larger annulus stress at the decompression level (L3-4) under all four moments than were seen in the SpinO model and healthy disc model, respectively. Therefore, the ConLa model with moderate disc degeneration showed the highest annulus stress at the decompression level (L3-4). However, the percent change of annulus stress at L3-4 from the intact model to the matched decompression model was less in the moderate disc degeneration model than in the healthy disc model.

Although the ConLa model with moderate disc degeneration showed the highest annulus stress, the degenerative models would be less influenced by the decompression technique.