Driving on urban roads: How we come to expect the 'correct' speed

Samuel G Charlton1, Nicola J Starkey1

  • 1Transport Research Group, School of Psychology, University of Waikato, New Zealand.

Related Concept Videos

Sight Distance in a Vertical Curve01:29

Sight Distance in a Vertical Curve

Sight distance on vertical curves is critical in roadway design. It ensures drivers can see far enough ahead to identify and respond to hazards effectively. This directly impacts safety, driver comfort, and the overall efficiency of the transportation network.Vertical curves are classified into crest and sag curves based on their geometry. For crest curves, sight distance is determined by the line of sight between a driver's eye and a small object on the road's surface. Design parameters for...
409
Introduction to Limits01:30

Introduction to Limits

A limit describes the value a function approaches as its input moves closer to a particular point. Even when a function is undefined at a specific value, limits allow us to analyze its behavior near that point. This concept is fundamental in calculus and essential for understanding continuity, derivatives, and integrals.Mathematically, a function f(x) has a limit L at x = a if its values L approach x as x gets arbitrarily close to a. This is written as:This notation expresses that the function...
298
Dynamics Of Circular Motion: Applications01:17

Dynamics Of Circular Motion: Applications

Suppose a car moves on flat ground and turns to the left. The centripetal force causing the car to turn in a circular path is due to friction between the tires and the road. For this, a minimum coefficient of friction is needed, or the car will move in a larger-radius curve and leave the roadway. Let's now consider banked curves, where the slope of the road helps in negotiating the curve. The greater the angle of the curve, the faster one can take the curve. It is common for race tracks for...
9.7K
Rolling Resistance: Problem Solving01:17

Rolling Resistance: Problem Solving

Rolling resistance, also known as rolling friction, is the force that resists the motion of a rolling object, such as a wheel, tire, or ball, when it moves over a surface. It is caused by the deformation of the object and the surface in contact with each other, as well as other factors like internal friction, hysteresis, and energy losses within the materials. Rolling resistance opposes the object's motion, requiring additional energy to overcome it and maintain movement. In practical...
870
Elevation of Intermediate Points on Vertical Curves01:20

Elevation of Intermediate Points on Vertical Curves

Vertical curves are essential in roadway design because they provide smooth transitions between varying roadway grades. Designing vertical curves involves calculating intermediate elevations and identifying the curve's highest or lowest point, which is essential for optimal roadway performance.Intermediate elevations on a vertical curve are determined using the tangent offset method. This method considers the initial elevation at the start of the curve, the grades, and the curve's geometry. The...
324
Determination of Expected Frequency01:08

Determination of Expected Frequency

Suppose one wants to test independence between the two variables of a contingency table. The values in the table constitute the observed frequencies of the dataset. But how does one determine the expected frequency of the dataset? One of the important assumptions is that the two variables are independent, which means the variables do not influence each other. For independent variables, the statistical probability of any event involving both variables is calculated by multiplying the individual...
2.6K