Related Experiment Video
Updated: Feb 21, 2026

Removal of Trace Elements by Cupric Oxide Nanoparticles from Uranium In Situ Recovery Bleed Water and Its Effect on Cell Viability
Published on: June 21, 2015
Reactive Transport of U and V from Abandoned Uranium Mine Wastes
Sumant Avasarala, Peter C Lichtner1, Abdul-Mehdi S Ali
1OFM Research-Southwest, Santa Fe, New Mexico 87507, United States.
Abstract:
The reactive transport of uranium (U) and vanadium(V) from abandoned mine wastes collected from the Blue Gap/Tachee Claim-28 mine site in Arizona was investigated by integrating flow-through column experiments with reactive transport modeling, and electron microscopy. The mine wastes were sequentially reacted in flow-through columns at pH 7.9 (10 mM HCO3-) and pH 3.4 (10 mM CH3COOH) to evaluate the effect of environmentally relevant conditions encountered at Blue Gap/Tachee on the release of U and V. The reaction rate constants (km) for the dissolution of uranyl-vanadate (U-V) minerals predominant at Blue Gap/Tachee were obtained from simulations with the reactive transport software, PFLOTRAN. The estimated reaction rate constants were within 1 order of magnitude for pH 7.9 (km = 4.8 × 10-13 mol cm-2 s-1) and pH 3.4 (km = 3.2 × 10-13 mol cm-2 s-1). However, the estimated equilibrium constants (Keq) for U-V bearing minerals were more than 6 orders of magnitude different for reaction at circumneutral pH (Keq = 10-38.65) compared to acidic pH (Keq = 10-44.81). These results coupled with electron microscopy data suggest that the release of U and V is affected by water pH and the crystalline structure of U-V bearing minerals. The findings from this investigation have important implications for risk exposure assessment, remediation, and resource recovery of U and V in locations where U-V-bearing minerals are abundant.
More Related Videos
12:05U2O5 Film Preparation via UO2 Deposition by Direct Current Sputtering and Successive Oxidation and Reduction with Atomic Oxygen and Atomic Hydrogen
Published on: February 21, 2019
12:22Speciation and Bioavailability Measurements of Environmental Plutonium Using Diffusion in Thin Films
Published on: November 9, 2015
Related Concept Videos
Nuclear Transmutation
Voltammetry: Stripping Methods
Anodic Stripping Voltammetry (ASV)
ASV is used to determine metals and metalloids at trace levels. It involves two steps: deposition and stripping. First, a negative potential is applied to the...