Carbon and Phosphorus Removal from Primary Municipal Wastewater Using Recovered Aluminum

In this work, recovery of aluminum from coagulated primary sludge and its reuse potential as secondary coagulant were investigated. The recovery process consisted of releasing the particle-bound aluminum from primary sludge by acidification (HCl or H₂SO₄), followed by separation using centrifugation for dissolved coagulant recovery. The recovered coagulant was then reused for treating primary wastewater and overall coagulation efficiency was determined. While with fresh alum, the removal efficiencies of total suspended solids, chemical oxygen demand, total phosphorus, and total nitrogen were 85%, 65%, 80% and 33%, respectively, a drop in removal efficiency of total suspended solids and chemical oxygen demand was observed for recovered aluminum (85-60% and 65-50%, respectively). Nitrogen concentration remained almost constant with each cycle, while phosphorus in the effluent increased by 1 mg/L and 3 mg/L in the first and second cycle, respectively. Precipitation of various aluminum species was modeled for determining the recovery potential of aluminum at low pH. Preliminary cost analysis indicates that optimum recovery of aluminum occurred at a pH of 1.5 for both acids. Struvite precipitation effectively removed increased phosphorus solubilized by acidification at the end of second cycle, however, it also decreased the amount of aluminum available for recycle.