Related Experiment Videos
Comparative Evaluation of Conventional and Accelerated Castings on Marginal Fit and Surface Roughness
Vivek Dattatray Jadhav1, Bhagwan K Motwani2, Jitendra Shinde1
1Department of Prosthodontics and Crown and Bridge, CSMSS Dental College and Hospital, Aurangabad, Maharashtra, India.
Aims:
The aim of this study was to evaluate the marginal fit and surface roughness of complete cast crowns made by a conventional and an accelerated casting technique.
Settings And Design:
This study was divided into three parts. In Part I, the marginal fit of full metal crowns made by both casting techniques in the vertical direction was checked, in Part II, the fit of sectional metal crowns in the horizontal direction made by both casting techniques was checked, and in Part III, the surface roughness of disc-shaped metal plate specimens made by both casting techniques was checked.
Materials And Methods:
A conventional technique was compared with an accelerated technique. In Part I of the study, the marginal fit of the full metal crowns as well as in Part II, the horizontal fit of sectional metal crowns made by both casting techniques was determined, and in Part III, the surface roughness of castings made with the same techniques was compared.
Statistical Analysis Used:
The results of the t-test and independent sample test do not indicate statistically significant differences in the marginal discrepancy detected between the two casting techniques.
Results:
For the marginal discrepancy and surface roughness, crowns fabricated with the accelerated technique were significantly different from those fabricated with the conventional technique.
Conclusions:
Accelerated casting technique showed quite satisfactory results, but the conventional technique was superior in terms of marginal fit and surface roughness.