Related Experiment Video

Updated: Feb 20, 2026

Automation of Mode Locking in a Nonlinear Polarization Rotation Fiber Laser through Output Polarization Measurements
14:18

Automation of Mode Locking in a Nonlinear Polarization Rotation Fiber Laser through Output Polarization Measurements

Published on: February 28, 2016

12.0K

Symmetry evaluation for an interferometric fiber optic gyro coil utilizing a bidirectional distributed polarization

Feng Peng, Chuang Li, Jun Yang

    Applied Optics
    |October 20, 2017
    PubMed

    More Related Videos

    A Photonic System for Generating Unconditional Polarization-Entangled Photons Based on Multiple Quantum Interference07:56

    A Photonic System for Generating Unconditional Polarization-Entangled Photons Based on Multiple Quantum Interference

    Published on: September 5, 2019

    9.0K
    Direct Imaging of Laser-driven Ultrafast Molecular Rotation10:52

    Direct Imaging of Laser-driven Ultrafast Molecular Rotation

    Published on: February 4, 2017

    10.3K

    Related Concept Videos

    Gyroscope: Precession01:24

    Gyroscope: Precession

    Precession can be demonstrated effectively through a spinning top. If a spinning top is placed on a flat surface near the surface of the Earth at a vertical angle and is not spinning, it will fall over due to the force of gravity producing a torque acting on its center of mass. However, if the top is spinning on its axis, it precesses about the vertical direction, rather than topple over due to this torque. Precessional motion is a combination of a steady circular motion of the axis and the...
    5.6K
    IR Spectrum Peak Splitting: Symmetric vs Asymmetric Vibrations01:08

    IR Spectrum Peak Splitting: Symmetric vs Asymmetric Vibrations

    Identical bonds within a polyatomic group can stretch symmetrically (in-phase) or asymmetrically (out-of-phase). Similar to hydrogen bonding, these vibrations also influence the shape of the IR peak. Generally, asymmetric stretching frequencies are higher than symmetric stretching frequencies. For example, primary amines exhibit two distinct IR peaks between 3300–3500 cm−1 corresponding to the symmetric and asymmetric N-H stretching, while secondary amines exhibit a single...
    1.9K
    Group Polarization01:01

    Group Polarization

    Group polarization is the strengthening of an original group attitude following the discussion of views within a group (Teger & Pruitt, 1967). That is, if a group initially favors a viewpoint, after discussion the group consensus is likely a stronger endorsement of the viewpoint. Conversely, if the group was initially opposed to a viewpoint, group discussion would likely lead to stronger opposition.
    39.2K
    Gyroscope01:02

    Gyroscope

    A gyroscope is defined as a spinning disk in which the axis of rotation is free to assume any orientation. When spinning, the orientation of the spin axis is unaffected by the orientation of the body that encloses it. The body or vehicle enclosing the gyroscope can be moved from place to place, while the orientation of the spin axis remains the same. This makes gyroscopes very useful in navigation, especially where magnetic compasses cannot be used, such as in crewed and crewless spacecraft,...
    4.3K
    Gauss's Law: Cylindrical Symmetry01:20

    Gauss's Law: Cylindrical Symmetry

    A charge distribution has cylindrical symmetry if the charge density depends only upon the distance from the axis of the cylinder and does not vary along the axis or with the direction about the axis. In other words, if a system varies if it is rotated around the axis or shifted along the axis, it does not have cylindrical symmetry. In real systems, we do not have infinite cylinders; however, if the cylindrical object is considerably longer than the radius from it that we are interested in,...
    9.6K
    Unsymmetric Bending - Angle of Neutral Axis01:15

    Unsymmetric Bending - Angle of Neutral Axis

    Unsymmetrical bending occurs when a structural member is subjected to bending moments in a plane that does not align with the member's principal axes. This scenario typically arises in beams and other structural components when loads are applied at non-ideal angles, introducing complexities in stress analysis.
    When a bending moment is applied at an angle θ concerning the vertical axis of a symmetrical member, it can be resolved into components along the member's principal...
    913