Related Experiment Video
Updated: Feb 20, 2026

Photodegradable Hydrogel Interfaces for Bacteria Screening, Selection, and Isolation
Published on: November 4, 2021
Study of the Effectiveness of Multipurpose Solutions on the Bacterial Disinfection of Silicone Hydrogel Contact
Priscila C Correa1, Aline C F Lui, Cely B Silva
1Department of Ophthalmology (P.C.C. and C.P.B.G.), Federal University of São Paulo, São Paulo, Brazil; Department of Ophthalmology (P.C.C., A.C.F.L., and A.L.N.), Medical Faculty of Santa Casa de Misericórdia de São Paulo, São Paulo, Brazil; Department of Hospital Infection Control of Irmandade da Santa Casa de Misericórdia de São Paulo (C.B.S.), São Paulo, Brazil; and Department of Pathology (L.M.M. and S.M.S.), Medical Faculty of Santa Casa de Misericórdia de São Paulo São Paulo, Brazil.
Objectives:
To assess the antimicrobial effectiveness of multipurpose solutions in regard to the disinfection of silicone hydrogel contact lenses (CL) using a study of clinical bacterial isolates from ocular material.
Methods:
Three multipurpose solutions (solution A: polyhexamethylene biguanide 0.00025 g/100 mL; solution B: polyquaternary-1 0.001% and myristamidopropyl dimethylamine 0.0006%; and solution C: polyaminopropyl biguanide 0.00013% and polyquaternary 0.0001%) were used as a 3-phase disinfection on silicone hydrogel CL contaminated with bacteria from clinical isolates that were divided into five groups (group 1: Pseudomonas aeruginosa; group 2: Staphylococcus aureus; group 3: Staphylococcus epidermidis; group 4: Streptococcus spp; and group 5: enterobacteria).
Results:
No differences were observed between the 24- and 48-hr measurements in any of the samples, and the positivity of microorganisms in T0 was 100% for all solutions; it was 0% in T3. Therefore, only steps T1 (rubbing followed by rinsing) and T2 (rubbing followed by rinsing and immersion of CL into solution) were considered for analysis at the 24-hr measurement time. Throughout the phases, a decrease in the number of bacteria was observed, culminating in the elimination (no recovery) of all microorganisms in the three solutions.
Conclusions:
At the end of the proposed process, the tested solutions were effective.
Related Concept Videos
Antimicrobial Effectiveness
Hand hygiene
Hand washing...
Chemical Agents for Microbial Control
Methods of Sterilization II: Chemical Methods
Using chemical sterilization rather than heat to clean out equipment is recommended. It eradicates and removes all bacteria,...

