Solid dispersion adsorbate technique for improved dissolution and flow properties of lurasidone hydrochloride:...

The aim of the present study was to improve the dissolution and flow properties of lurasidone hydrochloride (LH) by solid dispersion adsorbate (SDA) technique. Solid dispersions (SDs) of LH were prepared by fusion method using Poloxamer P188. The melt dispersion was adsorbed onto the porous carrier Florite (calcium silicate). A 3² factorial design was employed to quantify the effect of two independent variables, namely ratio of carrier (Poloxamer 188) and LH in SD and ratio of adsorbent (Florite) to SD. SDA granules of LH were studied for flow properties and characterized using differential scanning calorimetry, scanning electron microscopy, and X-ray diffraction. Tablets of optimized composition of SDA granules (equivalent to 20 mg of drug) and plain tablets were prepared by direct compression method. The dissolution studies were carried out in Mcllvaine buffer (pH 3.8) as per USFDA guidelines and characterized for parameters such as percent dissolution efficiency, t₅₀, and Q₃₀. Tablets prepared from SDA granules showed almost four-fold increase in cumulative percentage drug release as compared to tablets prepared from plain LH. The value of dissolution efficiency was enhanced from 49.60% for plain tablets to 94.15% for SDA tablets. SDA granules did not show any change in drug release and X-ray diffraction pattern after storage at 40 °C/75% of RH for 3 months, which confirms that Florite prevented conversion of drug from amorphous form to crystalline form improving physical stability of the amorphous state of LH.