Influence of clogging and resting processes on flow patterns in vertical flow constructed wetlands

Vertical flow constructed wetlands are widely used for removing pollutants from wastewater. Substrate clogging is an operational challenge of constructed wetlands, which can result in impeded water flow and finally a significant decline in the ability of the system to treat the wastewater. The entire clogging process in a vertical flow constructed wetland (VFCW) was quantitatively analyzed by measurements of hydraulic conductivity. Tracer tests and model simulations were carried out to investigate internal flow patterns during the clogging and resting processes. This analysis revealed that hydraulic conductivity gradually decreased with operation time. Further, the distribution time of the flow field was different under different degrees of clogging. Non-uniformity in water flow was primarily observed in the first 400min after adding the tracer (NaCl) in the early clogging stage, as opposed to the last 400min in the late clogging stage. Variation in water flow divergence was closely correlated with piston flow; the reaction efficiency was highest in the early stages of clogging. In the later stages, stronger flow mixing was observed. Resting operations can reduce the dispersion of internal flow and improve reaction efficiency. After resting for approximately 15days, tracer concentration fluctuations decreased and internal flow back-mixing was alleviated. A simulation further described the internal flow pattern and elaborated and validated the tracer experiment. The outcomes of this study will assist in understanding how internal flow behavior varies in response to the clogging process and reveal details of the internal clogging mechanism in VFCWs.