Heat generated during light-curing of restorative composites: Effect of curing light, exotherm, and experiment...

To investigate temperature rise, separating heat caused by irradiation and exotherm for three composites polymerized with three curing lights. The effect of substrate on temperature measurements was also determined.

Composite samples (n= 5) (Filtek Supreme Ultra, Filtek LS, and EsthetX HD) were placed on a thermocouple tip inside three substrates (aluminum, Delrin, and tooth). The composites were photoactivated using three curing lights (Elipar 2500 QTH, SmartLite Max LED, DemiUltra LED) at 1 mm distance. Irradiance was 798, 980, and 1,135 mW/cm2, respectively. Exotherm was determined by subtracting post-cure from the polymerization temperature curves. ANOVA and Student-Newman-Keuls post-hoc tests were used to analyze differences among peak temperatures and exotherms (significance level 0.05).

SmartLite LED curing light resulted in higher peak temperatures and exotherms compared to the DemiUltra LED and QTH for all tested composites (16.9-20.4°C vs 12.3-14.7°C vs 8.9-9.7°C). Thus, the LEDs produced higher temperature rises than the QTH, and the LED with lower irradiance caused higher temperature rise than the LED with higher irradiance. The silorane-based Filtek LS generated significantly higher exotherm than the methacrylate-based EsthetX HD and Filtek Supreme Ultra (6.2-7.6°C vs 3.6-4.5°C vs 2.7-3.6°C). Substrate affected temperatures significantly. Temperature profiles found in Delrin substrate were comparable to tooth substrate, while aluminum substrate reduced temperatures 10-20 degrees.

Curing of restorative composites raises the temperature under a restoration due to irradiation and exothermic reaction; how much the temperature increases depends on curing light design, type of composite, and surrounding substrate. The silorane-based Filtek LS generated significantly higher exotherm than the methacrylate-based EsthetX HD and Filtek Supreme Ultra.