Transmission-based precautions are for patients infected or suspected to be infected (or colonized) with organisms posing a significant risk to others. The transmission precautions include airborne and protective environment precautions.
Airborne precautions:
Use airborne precautions when treating patients known or suspected to have diseases that spread through the air—for example, tuberculosis or measles. These organisms are present in smaller droplets expelled by an infected person and...

Transmission-based precautions are for patients known to be infected or suspected to be infected or colonized with organisms that pose a significant risk to others. Some transmission-based precautions include contact, enteric, and droplet.
Contact Precautions:
Contact precautions are the measures taken to prevent the transmission of infectious agents, especially epidemiologically important microorganisms such as MRSA or influenza, primarily transmitted through direct or indirect contact with an...

Agonists can bind with and activate receptors, resulting in the formation of drug-receptor complexes. Once formed, these complexes catalyze many biochemical processes at the cellular level and subsequently induce a pharmacologic response. The degree of response is directly proportional to the fraction of activated receptors, which in turn, depends on the concentration of the drug at the receptor site as well as the sensitivity of the receptor. An increase in the administered dose contributes to...

The sequence of removing or doffing PPE starts with the gloves, as they are the most contaminated. Next is removal of the face shield or goggles, as they would interfere with removing other PPE. Then remove the gown, followed by the mask or respirator. Perform hand hygiene between steps if hands become contaminated and immediately after removing all PPE. Generally, the outside front and sleeves of the isolation gown, the goggles or the mask, the respirator, and the face shield are contaminated.

The potency of a drug is the measure of its ability to produce a biological response and can be compared by looking at the half-maximum effective concentration or EC50 values of different drugs. A lower EC50 value indicates higher potency of the drug. In the dose–response curve of two antihypertensive drugs, candesartan and irbesartan, a significant difference is observed in their EC50 values. A lower EC50 value for candesartan indicates that it is more potent than irbesartan, as it...