Related Experiment Video
Updated: Feb 16, 2026

Resonance Fluorescence of an InGaAs Quantum Dot in a Planar Cavity Using Orthogonal Excitation and Detection
Published on: October 13, 2017
Resonance Raman excitation profiles of CdS in pure CdS and CdSe/CdS core/shell quantum dots: CdS-localized excitons
Ke Gong1, David F Kelley1, Anne Myers Kelley1
1Chemistry and Chemical Biology, University of California, Merced, 5200 North Lake Road, Merced, California 95343, USA.
Abstract:
Resonance Raman excitation profiles have been measured for the longitudinal optical phonon in two sizes of CdS quantum dots and in CdSe/CdS core/shell quantum dots. In pure CdS, the resonance Raman cross section for the fundamental transition is sharply peaked around the lowest-energy excitonic transition and becomes weaker with higher-energy excitation even though the absorbance continues to increase to higher energies. This effect, also observed in earlier studies of CdSe quantum dots, is attributed largely to interferences among multiple excitonic transitions contributing to the resonance Raman polarizability. No variation in exciton-phonon coupling strength with exciton energy is required to explain the decrease in the ratio of the Raman cross section to absorption cross section at shorter wavelengths. In core/shell structures, the CdSe phonons are relatively strong when exciting on resonance with the lower excitonic transitions, in which the hole is largely localized to the CdSe core, but become nearly undetectable at excitation wavelengths >0.6 eV above the lowest exciton, where both electrons and holes are largely localized in the CdS shell. The CdS phonon Raman cross section exhibits a maximum 0.6-0.7 eV above the lowest exciton and then decreases at higher energies for the same reasons as in pure CdS.
Related Concept Videos
Raman Spectroscopy: Overview
However, a small fraction of the scattered light exhibits a frequency shift due to the exchange of energy between the incident photons and...
Raman Spectroscopy Instrumentation: Overview
The monochromatic laser source, typically using visible or near-infrared radiation, generates a highly focused beam of light. This light interacts with the molecules of the sample, scattering some of the light. Liquid and gaseous samples are usually tested in ordinary glass capillaries, while solids can be analyzed as powders packed in capillaries or as potassium...
Molecular Spectroscopy: Absorption and Emission
¹H NMR: Interpreting Distorted and Overlapping Signals
As Δν decreases and the signals move closer, the doublets appear increasingly distorted. The intensities of the inner lines increase at the cost of those of the outer lines as the signals are...
UV–Vis Spectroscopy: Molecular Electronic Transitions
Double Resonance Techniques: Overview
Spin decoupling is usually achieved by...

