Related Experiment Video
Updated: Feb 16, 2026

Synthesis and Functionalization of 3D Nano-graphene Materials: Graphene Aerogels and Graphene Macro Assemblies
Published on: November 5, 2015
Study of graphene dispersions in sodium dodecylsulfate by steady-state fluorescence of pyrene
S Vera-López1, P Martínez1, M P San Andrés1
1Department of Analytical Chemistry, Physical Chemistry, and Chemical Engineering, University of Alcalá, 28871 Madrid, Spain.
Hypothesis:
Aqueous solutions of ionic surfactants allow the exfoliation of graphene, that can be explained considering the adsorption model of ionic surfactants to hydrophobic surfaces. For many years, pyrene has been used as a fluorescent probe because its sensitivity to the micro-environment. The study of pyrene fluorescence in the presence of different graphene dispersions in an ionic surfactant, would improve the knowledge of the graphene-surfactant interactions.
Experiments:
Different dispersions of graphene in sodium dodecylsulfate were prepared at different weight ratios 0.5, 1 and 2%. The dispersions have been studied by Raman spectroscopy, scanning electron microscopy and transmission electron microscopy. The influence of the dispersions on the pyrene fluorescence has been investigated.
Findings:
The graphene sheets modified by the surfactant quench the fluorescence of pyrene, which depends on the amount of graphene, the concentration of surfactant and the weight ratio. For surfactant concentrations below the critical micelle concentration, the quenching effect is higher as the weight ratio increases. Once this concentration is reached, the fluorescence increases slightly and then levels off. This behavior has been explained by the adsorption model. For a constant surfactant concentration, two straight lines can be observed in the Stern-Volmer plots whose cut-off point is approximately 20 mg L-1 of graphene.
More Related Videos
Related Concept Videos
Distribution and Dispersion
Steady State Concentration
Most drugs are administered in repeated doses at fixed intervals or through continuous...
Steady Flow of a Fluid Stream
During this process, the momentum of the fluid within the control volume remains constant over the time interval dt. By applying the...
Transient and Steady-state Response
These test signals are integral in designing control systems to exhibit two key performance aspects: transient response and steady-state...
Velocity and Acceleration in Steady and Unsteady Flow
The acceleration can be generalized to any point in the flow, and expressed as components along three perpendicular directions, representing changes in velocity over...
Regulation of Sodium and Potassium
Sodium Regulation
Sodium ions make up approximately 90% of extracellular cations, with a normal blood plasma concentration of 136–148 mEq/L. A decrease in blood volume and pressure triggers the release of renin from granular cells in the juxtaglomerular complex (JGC), primarily...

