Related Experiment Video
Updated: Feb 16, 2026

A Whole Mount In Situ Hybridization Method for the Gastropod Mollusc Lymnaea stagnalis
Published on: March 15, 2016
New Insights to Compare and Choose TKTD Models for Survival Based on an Interlaboratory Study for Lymnaea stagnalis
Virgile Baudrot1, Sara Preux1,2, Virginie Ducrot3
1Univ Lyon, Université Lyon 1 , UMR CNRS 5558, Laboratoire de Biométrie et Biologie Évolutive, F-69100 Villeurbanne, France.
Abstract:
Toxicokinetic-toxicodynamic (TKTD) models, as the General Unified Threshold model of Survival (GUTS), provide a consistent process-based framework compared to classical dose-response models to analyze both time and concentration-dependent data sets. However, the extent to which GUTS models (Stochastic Death (SD) and Individual Tolerance (IT)) lead to a better fitting than classical dose-response model at a given target time (TT) has poorly been investigated. Our paper highlights that GUTS estimates are generally more conservative and have a reduced uncertainty through smaller credible intervals for the studied data sets than classical TT approaches. Also, GUTS models enable estimating any x% lethal concentration at any time (LCx,t), and provide biological information on the internal processes occurring during the experiments. While both GUTS-SD and GUTS-IT models outcompete classical TT approaches, choosing one preferentially to the other is still challenging. Indeed, the estimates of survival rate over time and LCx,t are very close between both models, but our study also points out that the joint posterior distributions of SD model parameters are sometimes bimodal, while two parameters of the IT model seems strongly correlated. Therefore, the selection between these two models has to be supported by the experimental design and the biological objectives, and this paper provides some insights to drive this choice.
Related Concept Videos
Comparing the Survival Analysis of Two or More Groups
Choosing Between z and t Distribution
Survival Curves
The Kaplan-Meier estimator is the most common method for constructing survival curves. This...
Survival Tree
Building a Survival Tree
Constructing a...
Introduction To Survival Analysis
The primary goal of survival analysis is to estimate survival time—the time...
Truncation in Survival Analysis
Left truncation occurs when individuals who experienced the event of interest before a certain time are not included in the study. This is often due to a "delayed entry" into the study where only those who survive until a certain entry point are...

