Optical Recording of Membrane Potential Changes From Single Neurons Using Intracellular Voltage-Sensitive Dyes

Overview

The relative difference in electrical charge, or voltage, between the inside and the outside of a cell membrane, is called the membrane potential. It is generated by differences in permeability of the membrane to various ions and the concentrations of these ions across the membrane.
The Inside of a Neuron is More Negative
The membrane potential of a cell can be measured by inserting a microelectrode into a cell and comparing the charge to a reference electrode in the extracellular fluid. The...

Once a ligand binds to a receptor, the signal is transmitted through the membrane and into the cytoplasm. The continuation of a signal in this manner is called signal transduction. Signal transduction only occurs with cell-surface receptors, which cannot interact with most components of the cell, such as DNA. Only internal receptors can interact directly with DNA in the nucleus to initiate protein synthesis. When a ligand binds to its receptor, conformational changes occur that affect the...

The movement of electrons in a conductor requires some form of energy or work, usually provided by an external force, like a battery. This force is called the electromotive force or voltage. The voltage between two points, referred to as points "a" and "b," in an electric circuit is the energy (or work) needed to move a unit charge from point "a" to point "b," and this relationship is expressed mathematically as

Generally, a single battery is not enough to power some devices. In such cases, batteries can be combined in two ways: in series or in parallel.
In series, the positive terminal of one battery is connected to the negative terminal of another battery. Hence, the voltage of each battery is added to give the net voltage, which is increased because each battery boosts the electrons that enter it. The same current flows through each battery because they are connected in series.
Batteries are...

In electrical circuits, resistors can be connected in series, sequentially linked one after the other. In a series configuration, the same current flows through each resistor. Ohm's law is a fundamental principle to understand the behavior of resistors in series. It expresses the voltage across these resistors in terms of the current and resistance.
Kirchhoff's voltage law implies that the sum of the voltages across the resistors in series equals the source voltage. This means that the current...