Antithrombin concentrate use in disseminated intravascular coagulation of sepsis: meta-analyses revisited

C J Wiedermann1

  • 1UMIT - The Health and Life Sciences University, Hall, Tyrol, Austria.

Recently, two meta-analyses examined the effect of antithrombin on mortality in patients with sepsis and disseminated intravascular coagulation (DIC) with diverging results. In the meta-analysis observing no significant survival effect of antithrombin, the results of a large trial were included under the assumption that all 2314 participants of the trial had sepsis and DIC, which according to post hoc analyses was not the case. To the other meta-analysis reporting beneficial effect, the same trial contributed only those 229 patients that had confirmed sepsis-induced DIC. Replacing the mixed sepsis patient group with and without DIC with the group of sepsis patients with confirmed DIC provides evidence for a beneficial intervention effect of antithrombin also in the meta-analysis that reported no beneficial effect of antithrombin on mortality. This revised result does not change the overall conclusion that the quantity and quality of evidence supporting the use of antithrombin in sepsis patients with DIC is low.

Related Concept Videos

Coagulation01:06

Coagulation

Colloidal solids are solid particles suspended in solution. They are usually negatively charged, attracting a compact primary layer of positively charged ions, which attract more counterions to form an electrical double layer. Electrostatic repulsion between the charged double layers prevents the particles from colliding, stabilizing the colloids. These solids are often undesirable because they can contain toxins that are difficult to remove. Coagulation is a technique that helps aggregate and...
1.5K
Coagulation01:09

Coagulation

The coagulation phase is a critical part of the body's process to prevent blood loss following injury to blood vessels. It involves chemical reactions that form a clot to seal the injured area. The clotting process begins shortly after injury, within 15-20 seconds for severe damage and 1-2 minutes for minor injuries.
During the coagulation phase, clotting factors, or procoagulants, play a vital role in initiating and progressing the coagulation cascade. This cascade is a series of reactions...
10.8K
Directing Effect of Substituents: meta-Directing Groups01:09

Directing Effect of Substituents: meta-Directing Groups

Substituents on the benzene ring that direct an incoming electrophile to undergo substitution at the meta position are called meta directors. All meta directors either have a positive charge on the atom directly bonded to the ring or a partial positive charge. These groups function by withdrawing electrons from the ring through inductive and resonance effects. Consider the carbocation intermediates formed upon the addition of an electrophile on nitrobenzene at the...
6.1K
Concentration Cells02:41

Concentration Cells

A concentration cell is a type of a  voltaic cell constructed by connecting two almost identical half-cells, both based on the same half-reaction and using the same electrode, differing only in the concentration of one redox species. A concentration cell's potential, therefore, is determined only by the concentration difference of the particular redox species.
Consider the following voltaic cell:
25.9K
Solution Concentration and Dilution02:59

Solution Concentration and Dilution

The relative amount of a given solution component is known as its concentration. Often, though not always, a solution contains one component with a concentration that is significantly greater than that of all other components. This component is called the solvent and may be viewed as the medium in which the other components are dispersed or dissolved. Solutions in which water is the solvent are, of course, very common on our planet. A solution in which water is the solvent is called an aqueous...
135.6K
Stress Concentrations01:13

Stress Concentrations

The concept of stress concentration is crucial for understanding how materials respond under bending stresses, particularly when there are irregularities or discontinuities in the material's geometry. Normally, stress in a symmetric member subjected to pure bending is assumed to be uniformly distributed across the entire cross-section. However, this assumption does not hold when there are variations in the cross-sectional geometry or the presence of notches and holes.
The stress...
664