The effect of constraints on the analytical figures of merit achieved by extended multivariate curve

Rocío B Pellegrino Vidal1, Franco Allegrini1, Alejandro C Olivieri1

  • 1Instituto de Química Rosario (CONICET-UNR), Departamento de Química Analítica, Facultad de Ciencias Bioquímicas y Farmacéuticas, Universidad Nacional de Rosario, Suipacha 531, 2000, Rosario, Argentina.

Analytica Chimica Acta
|January 11, 2018
PubMed

Related Concept Videos

Calibration Curves: Linear Least Squares01:20

Calibration Curves: Linear Least Squares

A calibration curve is a plot of the instrument's response against a series of known concentrations of a substance. This curve is used to set the instrument response levels, using the substance and its concentrations as standards. Alternatively, or additionally, an equation is fitted to the calibration curve plot and subsequently used to calculate the unknown concentrations of other samples reliably.
For data that follow a straight line, the standard method for fitting is the linear...
4.6K
Uncertainty in Measurement: Significant Figures03:34

Uncertainty in Measurement: Significant Figures

All the digits in a measurement, including the uncertain last digit, are called significant figures or significant digits. Note that zero may be a measured value; for example, if a scale that shows weight to the nearest pound reads “140,” then the 1 (hundreds), 4 (tens), and 0 (ones) are all significant (measured) values.
84.3K
Rules for Significant Figures01:44

Rules for Significant Figures

In any measurement, the precision of the measuring tool is an essential factor. An ordinary ruler, for example, can measure length to the closest millimeter; a caliper, on the other hand, can measure length to the nearest 0.01 mm. As a result, the caliper is a more precise measurement tool because it can measure extremely minute changes in length. The measurements will be more accurate if the measuring tool is more precise.
It should be emphasized that when we represent measured values, the...
40.4K
Punnett Squares01:00

Punnett Squares

Overview
125.9K
Significant Figures in Calculations00:58

Significant Figures in Calculations

Uncertainty in measurements can be avoided by reporting the results of a calculation with the correct number of significant figures. This can be determined by the following rules for rounding numbers:
20.2K
Constraints and Statical Determinacy01:26

Constraints and Statical Determinacy

In structural engineering, the equilibrium of a system is not only determined by its equations of equilibrium but also with the help of constraints. Constraints refer to restrictions on the motion of a system. The proper combinations of constraints can minimize the total number of constraints needed to maintain a system in mechanical equilibrium. When this happens, the system is said to be statically determinate. For such systems, the unknown reaction supports can be estimated using equilibrium...
1.0K