Related Experiment Video
Updated: Feb 15, 2026

Thermal Ablation for the Treatment of Abdominal Tumors
Published on: March 7, 2011
Does doxorubicin survive thermal ablation? Results of an ex vivo bench top study
Joseph D Morrison1, Collin K Schlager2, Amanda E Lee3
1Department of Radiology, University of Illinois College of Medicine, Chicago, Illinois, USA.
Purpose:
We aimed to test the hypothesis that doxorubicin (DOX) survives thermal ablative heating in an ex vivo model of combined transarterial chemoembolization (TACE) and thermal ablation.
Methods:
Fresh porcine psoas major muscle (3 samples, 15×10×3 cm) was submerged in aqueous DOX solution (60 µg/mL, 0.1 M) for 24 hours to passively saturate tissue. DOX-infused tissue was then dried and treated with microwave ablation (MWA) using a 2.45 GHz antenna at 65 W for 2, 5, and 10 minutes. Ablations were repeated in triplicate (9 total). Tissue was then sampled at both ablated and unablated control sites, and DOX concentration was quantified via ultra-high performance liquid chromatography tandem mass spectrometry (UHPLC-MS/MS), with samples analyzed in triplicate. Tissue DOX levels in ablation and control groups were compared using one-way ANOVA.
Results:
Homogeneous DOX uptake into porcine tissue was evident in all three samples. Mean DOX concentration in unablated tissue was 8.0±2.2 µg/mL. MWA was technically successful in all 9 procedures (100%), with tissue heating to 95-100°C. Mean tissue DOX concentration showed progressive reduction with increasing ablation time, measuring 6.7±1.3, 4.9±0.9, and 4.8±1.3 µg/mL in MWA-treated tissue after 2, 5, and 10 minutes, respectively. Differences in tissue DOX levels between unablated tissue and MWA groups were statistically significant (P < 0.001).
Conclusion:
Contrary to the initial hypothesis, tissue DOX concentration progressively decreased after MWA of longer ablation times. These results suggest that TACE followed by ablation may result in lower intratumoral DOX than would otherwise be anticipated for TACE alone.
Related Concept Videos
Survival Curves
The Kaplan-Meier estimator is the most common method for constructing survival curves. This...
Survival Tree
Building a Survival Tree
Constructing a...
Thermal expansion and Thermal stress: Problem Solving
To solve the problem, first, identify the known and unknown quantities. The initial length (L) of the bridge is 1275 m, the coefficient of linear expansion (α) for steel is 12 x 10-6/°C, and the change in temperature (ΔT) is 55...
Introduction To Survival Analysis
The primary goal of survival analysis is to estimate survival time—the time...
Comparing the Survival Analysis of Two or More Groups
Truncation in Survival Analysis
Left truncation occurs when individuals who experienced the event of interest before a certain time are not included in the study. This is often due to a "delayed entry" into the study where only those who survive until a certain entry point are...

