Randomized Clinical Trial Comparing Low Density versus High Density Meshes in Patients with Bilateral Inguinal Hernia

The American Surgeon
|January 17, 2018
PubMed

Related Concept Videos

Density00:56

Density

Density is an important characteristic of substances, crucial in determining whether an object sinks or floats in a fluid. Its SI unit is kg/m3, and its cgs unit is g/cm3. The density of an object helps in identifying its composition, and also reveals information about the phase of the matter and its substructure. The densities of liquids and solids are roughly comparable, consistent with the fact that their atoms are in close contact. However, gases have much lower densities than liquids and...
20.0K
Clinical Trials01:16

Clinical Trials

Clinical trials are prospective experimental studies conducted on humans to determine the safety and efficacy of treatments, drugs, diet methods, and medical devices. Using statistics in clinical trials enables researchers to derive reasonable and accurate conclusions from the collected data, allowing them to make wise decisions in uncertain situations. In medical research, statistical methods are crucial for preventing errors and bias.
There are four phases in a clinical trial. A phase one...
10.9K
Current Density01:21

Current Density

The total amount of current flowing through one unit value of a cross-sectional area is referred to as current density. If the current flow is uniform, the amount of current flowing through a conductor is the same at all points along the conductor, even if the conductor area varies. The current density consists of the local magnitude and direction of the charge flow, which varies from point to point. Current density is measured in amperes per meter square, and direction is defined as the net...
5.2K
Clinical Trials: Overview01:11

Clinical Trials: Overview

Clinical development focuses on how the drug will interact with the human body and encompasses four key phases of clinical trials, each serving a specific purpose in assessing the safety and effectiveness of new drugs. These phases overlap and build upon one another. Phase I involves a small group of healthy volunteers (typically 20-80 individuals) or, in cases where significant toxicity is expected, patients with the targeted disease, such as cancer or AIDS. The volunteers are tested for...
5.1K
Strain-Energy Density01:20

Strain-Energy Density

Understanding the strain energy density in materials under axial load is crucial for evaluating their mechanical behavior and durability. When a rod is subjected to such a load, it elongates and stores energy, known as strain energy, as potential energy within the material. This energy is measured in terms of energy per unit volume.
In the elastic region of a material, the relationship between the stress and the strain is linear and follows Hooke's Law. The strain energy density in this region...
947
Bulk Density of Aggregate01:22

Bulk Density of Aggregate

Bulk density refers to the mass of aggregate particles that would fill a unit volume. The concept of bulk density originates from the inability to pack aggregate particles in a manner that completely eliminates void spaces. Hence, the term bulk refers to the volume that encompasses both the aggregates and the voids. This measurement is crucial when aggregates are batched by volume and is used to convert quantities by mass to volume.
Most natural mineral aggregates, like sand and gravel,...
1.2K