Related Experiment Video
Updated: Feb 15, 2026

Optimize Flue Gas Settings to Promote Microalgae Growth in Photobioreactors via Computer Simulations
Published on: October 1, 2013
Improving Flue Gas Mercury Removal in Waste Incinerators by Optimization of Carbon Injection Rate
Guoliang Li1,2, Qingru Wu1,2, Shuxiao Wang1,2
1State Key Joint Laboratory of Environment Simulation and Pollution Control, School of Environment, Tsinghua University , Beijing 100084, China.
Abstract:
This study tested the mercury emission characteristics of six municipal solid waste incinerators (MSWIs) and recommended future mercury control via adjusting operational parameters. The results indicated that over 99% of the mercury in solid wastes ended in fly ash and flue gas, of which 3.3-66.3% was emitted to air through stack gas. Mercury in the stack gas was mainly in the form of oxidized mercury (Hg2+), the proportion (65.4-89.0%) of which was far higher than previous estimation (15%). Mercury removal efficiencies (MRE) of the tested incinerators were in the range of 33.6-95.2%. The impact of waste incineration capacity, gas flow, fly ash yield, and activated carbon (AC) injection on MRE were analyzed. We found that the MRE was significantly linearly correlated to the ratio of AC injection and fly ash yield (correlation coefficient = 0.98, significance <0.01). AC injection value is determined based on the control of dioxin emissions without considering mercury control in traditional design. To increase MRE of MSWIs, the AC injection should increase from around 100 mg·Nm-3 to 135 mg·Nm-3 for grate furnace combustor and 170 mg·Nm-3 for circulation fluidized bed combustor, so as to reach a MRE of 90%.
Related Concept Videos
Gas Chromatography: Sample Injection Systems
Two primary injection methods are used...
Gas Exchange and Transport
The Carbon Cycle
Measuring Reaction Rates
Carbon Skeletons
Reaction Rate
The mathematical representation of the change in the concentration of reactants and products, over time, is the rate...

