Related Experiment Video
Updated: Feb 14, 2026

Measuring and Manipulating Functionally Specific Neural Pathways in the Human Motor System with Transcranial Magnetic Stimulation
Published on: February 23, 2020
Maximum human objectively measured pharmacologically stimulated accommodative amplitude
Andrzej Grzybowski1,2, Ronald A Schachar3, Magdalena Gaca-Wysocka2
1Institute for Research in Ophthalmology, Foundation for Ophthalmology Development, Poznan.
Purpose:
To measure the maximum, objectively measured, accommodative amplitude, produced by pharmacologic stimulation.
Methods:
Thirty-seven healthy subjects were enrolled, with a mean age of 20.2±1.1 years, corrected visual acuity of 20/20, and mean spherical equivalent refraction (SER) =-0.83±1.60 diopters. For each subject, the right pupil was dilated with phenylephrine 10%. After 30 minutes, the pupil was measured, the left eye was patched, and the right eye was autorefracted. Pilocarpine 4% was then instilled in the right eye, followed by phenylephrine. At 45 minutes after the pilocarpine, autorefraction and pupil size were again measured.
Results:
Mean pupil size pre- and postpilocarpine was 8.0±0.8 mm and 4.4±1.9 mm, respectively. Pre- and postpilocarpine, the mean SER was -0.83±1.60 and -10.55±4.26 diopters, respectively. The mean pilocarpine-induced accommodative amplitude was 9.73±3.64 diopters. Five subjects had accommodative amplitudes ≥14.00 diopters. Accommodative amplitude was not significantly related to baseline SER (p-value =0.24), pre- or postpilocarpine pupil size (p-values =0.13 and 0.74), or change in pupil size (p-value =0.37). Iris color did not statistically significantly affect accommodative amplitude (p-value =0.83).
Conclusion:
Following topically applied pilocarpine, the induced objectively measured accommodation in the young eye is greater than or equal to the reported subjectively measured voluntary maximum accommodative amplitude.
Related Concept Videos
Maximum Deflection
The maximum deflection occurs at a specific point, known as point O, where the tangent to the deflection curve is horizontal. To find point O, the slope of the tangent at any...
Pulse amplitude and quality
A weak or absent pulse may indicate reduced cardiac output or poor left ventricular contraction, which can be signs of cardiovascular dysfunction or...
Maximum Power Transfer
By substituting the entire circuit with...
Maximum Size of Aggregate
The Maximum Power Transfer Theorem
The load connected draws the current, and the circuit delivers the power to the load. The alternating current flowing through the load is determined using the rectangular form of voltages, currents, network impedance, and load impedance. The average power delivered to the load is obtained from the product of the square of current and load resistance.
Maximum Power Flow and Line Loadability

