The yield difference between wild-type cotton and transgenic cotton that expresses IPT depends on when water-deficit

Xunlu Zhu1, Li Sun1, Sundaram Kuppu1

  • 1Department of Biological Sciences, Texas Tech University, Lubbock, TX, 79409, USA.

Scientific Reports
|February 9, 2018
PubMed

Related Concept Videos

ATP Yield01:31

ATP Yield

Cellular respiration produces 30 - 32 ATP per glucose molecule. Although most of the ATP results from oxidative phosphorylation and the electron transport chain (ETC), 4 ATP are gained beforehand (2 from glycolysis and 2 from the citric acid cycle).
The ETC is embedded in the inner mitochondrial membrane and is comprised of four main protein complexes and an ATP synthase. NADH and FADH2 pass electrons to these complexes, which pump protons into the intermembrane space. This distribution of...
79.2K
Yield Criteria for Ductile Materials under Plane Stress01:25

Yield Criteria for Ductile Materials under Plane Stress

In designing structural elements and machine parts using ductile materials, it is crucial to ensure that these components withstand applied stresses without yielding. Yielding is initially determined through a tensile test, which evaluates the material's response to uniaxial stress. However, tensile stress is insufficient when components face biaxial or plane stress conditions This condition requires advanced criteria to predict failure.
The Maximum Shearing Stress Criterion, also known as...
579
Reaction Yield02:22

Reaction Yield

The theoretical yield of a reaction is the amount of product estimated to form based on the stoichiometry of the balanced chemical equation. The theoretical yield assumes the complete conversion of the limiting reactant into the desired product. The amount of product that is obtained by performing the reaction is called the actual yield, and it may be less than or (very rarely) equal to the theoretical yield.
60.8K
Transgenic Organisms00:53

Transgenic Organisms

Overview
33.7K
States of Water01:23

States of Water

Water exists in any one of the three classical states: solid (ice), liquid (water), and gas (steam or water vapor). The state of water depends on i) the intermolecular forces that draw molecules together and ii) the kinetic energy that leads to movements that pull them apart.
Water freezes when the intermolecular forces are greater than the kinetic energy. Unlike most other substances, water is less dense in its solid state than in its liquid state. This is because each water molecule can form...
57.5K
The Integrated Rate Law: The Dependence of Concentration on Time02:39

The Integrated Rate Law: The Dependence of Concentration on Time

While the differential rate law relates the rate and concentrations of reactants, a second form of rate law called the integrated rate law relates concentrations of reactants and time. Integrated rate laws can be used to determine the amount of reactant or product present after a period of time or to estimate the time required for a reaction to proceed to a certain extent. For example, an integrated rate law helps determine the length of time a radioactive material must be stored for its...
44.1K