Evaluating differences in the active-site electronics of supported Au nanoparticle catalysts using Hammett and DFT

Gaurav Kumar1, Luke Tibbitts2, Jaclyn Newell2

  • 1Department of Chemical Engineering, The Pennsylvania State University, University Park, Pennsylvania 16802-4400 USA.

Nature Chemistry
|February 21, 2018
PubMed

Related Concept Videos

Relation of DFT to z-Transform01:20

Relation of DFT to z-Transform

The Discrete Fourier Transform (DFT) is a crucial tool for analyzing the frequency content of discrete-time signals. It converts a sequence of N samples from the time domain into its corresponding sequence in the frequency domain, where each sample represents a specific frequency component.
To understand how the DFT works, it's helpful to consider the z-transform, which is a method for representing discrete sequences in the complex frequency domain. The z-transform involves summing the...
848
Self-Help Support Groups01:28

Self-Help Support Groups

Self-help support groups are voluntary, community-based organizations that provide a platform for individuals with shared concerns to exchange support, insights, and practical strategies for coping with life challenges. Typically led by group members or paraprofessionals, these groups form a cornerstone of mental health care, especially in reaching populations that are underserved by traditional healthcare systems.
Accessibility and Cost-Effectiveness
One of the primary strengths of self-help...
365
Activation Energy01:26

Activation Energy

Activation energy is the minimum amount of energy necessary for a chemical reaction to move forward. The higher the activation energy, the slower the rate of the reaction. However, adding heat to the reaction will increase the rate, since it causes molecules to move faster and increase the likelihood that molecules will collide. The collision and breaking of bonds represents the uphill phase of a reaction and generates the transition state. The transition state is an unstable high-energy state...
87.2K
Electric Potential and Potential Difference01:16

Electric Potential and Potential Difference

Suppose a positive test charge moves away from a positive static charge, then the Coulomb force does positive work, and its electric potential energy decreases. The potential energy per unit charge is defined as the electric potential. The electric potential is independent of the test charge.
When a test charge moves from the initial to the final position, the electric potential difference between those positions is defined as the ratio of the change in the potential energy to the charge on the...
5.8K
Difference from Background: Limit of Detection01:05

Difference from Background: Limit of Detection

The limit of detection (LOD) is the smallest amount of analyte that can be distinguished from the background noise. The LOD value corresponds to the concentration at which the analyte signal is three times larger than the standard deviation of the blank signal. Below this value, the analyte signal cannot be differentiated from the background noise. It is calculated by dividing the calibration slope by 3 times the standard deviation of the blank signals.
The LOD indicates the presence or absence...
8.4K
Identifying Statistically Significant Differences: The F-Test01:14

Identifying Statistically Significant Differences: The F-Test

The F-test is used to compare two sample variances to each other or compare the sample variance to the population variance. It is used to decide whether an indeterminate error can explain the difference in their values. The underlying assumptions that allow the use of the F-test include the data set or sets are normally distributed, and the data sets are independent of each other. The test statistic F is calculated by dividing one variance by another. In other words, the square of one standard...
3.9K