Fatigue and quasi-static mechanical behavior of bio-degradable porous biomaterials based on magnesium alloys

R Hedayati1,2, S M Ahmadi1, K Lietaert3,4

  • 1Faculty of Mechanical, Maritime, and Materials Engineering, Department of Biomechanical Engineering, Delft University of Technology (TU Delft), Mekelweg 2, Delft, 2628 CD, The Netherlands.

Related Concept Videos

Regulated Protein Degradation02:58

Regulated Protein Degradation

It is vital to regulate the activity of enzymatic as well as non-enzymatic proteins inside the cell. This can be achieved either through creating a balance between their rate of synthesis and degradation or regulating the intrinsic activity of the protein. Both these regulation mechanisms play an essential role in the normal functioning of cells.
Protein degradation plays two important roles in the cells. It helps to protect cells from misfolded or damaged proteins before they lead to a...
8.9K
Fatigue01:21

Fatigue

Fatigue occurs when materials rupture under repeated or fluctuating loads, even at stress levels far below their static breaking strength. It typically results in brittle failure, even for ductile materials. It is a critical consideration in designing machines and structural components subjected to repetitive or varying loads. The nature of these loadings can range from fluctuating loads like unbalanced pump impellers causing vibrations to repeatedly bending a thin steel rod wire back and forth...
865
Proteins: From Genes to Degradation02:11

Proteins: From Genes to Degradation

Within a biological system, the DNA encodes the RNA, and the nucleotide sequence in the RNA further defines the amino acid sequence in the protein. This is referred to as “The Central Dogma of Molecular Biology” - a term coined by Francis Crick.  Central dogma is a firm principle in biology that defines the flow of genetic information within any life form. The two fundamental steps in central dogma are - transcription and translation.
Transcription is the synthesis of RNA...
14.6K
Static Equilibrium - I01:05

Static Equilibrium - I

A rigid body is said to be in dynamic equilibrium when both its linear and angular acceleration are zero, relative to an inertial frame of reference. This means that a body in equilibrium can be moving, but only when its linear and angular velocities are constant. A rigid body is said to be in static equilibrium when it is at rest in the selected frame of reference. The distinction between static equilibrium (e.g., a state of rest) and dynamic equilibrium (e.g, a state of uniform motion) is...
18.9K
Static Equilibrium - II01:07

Static Equilibrium - II

Static equilibrium is a special case in mechanics that is very important in everyday life. It occurs when the net force and the net torque on an object or system are both zero. This means that both the linear and angular accelerations are zero. Thus, the object is at rest, or its center of mass is moving at a constant velocity. However, this does not mean that no forces are acting on the object within the system. In fact, there are very few scenarios on Earth in which no forces are acting upon...
10.0K
Static Friction01:18

Static Friction

Static friction is a force that opposes the relative motion or tendency of motion between two surfaces in contact. It plays a crucial role in our daily lives, from walking on the ground to driving a car.
For example, consider a scenario where a truck is connected to a car by a rope, ready to tow it along a road. When no external force is applied by the truck, the car remains stationary and is said to be in static equilibrium. In this case, the forces acting on the car, such as gravity and the...
1.5K