Related Experiment Video
Updated: Feb 13, 2026

Optimized Fabrication Procedure for High-Quality Graphene-based Moiré Superlattice Devices
Published on: July 11, 2025
Imaging Bulk and Edge Transport near the Dirac Point in Graphene Moiré Superlattices
Ziwei Dou1, Sei Morikawa2, Alessandro Cresti3
1Cavendish Laboratory, Department of Physics , University of Cambridge , Cambridge CB3 0HE , United Kingdom.
Abstract:
Van der Waals structures formed by aligning monolayer graphene with insulating layers of hexagonal boron nitride exhibit a moiré superlattice that is expected to break sublattice symmetry. Despite an energy gap of several tens of millielectronvolts opening in the Dirac spectrum, electrical resistivity remains lower than expected at low temperature and varies between devices. While subgap states are likely to play a role in this behavior, their precise nature is unclear. We present a scanning gate microscopy study of moiré superlattice devices with comparable activation energy but with different charge disorder levels. In the device with higher charge impurity (∼1010 cm-2) and lower resistivity (∼10 kΩ) at the Dirac point we observe current flow along the graphene edges. Combined with simulations, our measurements suggest that enhanced edge doping is responsible for this effect. In addition, a device with low charge impurity (∼109 cm-2) and higher resistivity (∼100 kΩ) shows subgap states in the bulk, consistent with the absence of shunting by edge currents.
More Related Videos
07:51Development and Functionalization of Electrolyte-Gated Graphene Field-Effect Transistor for Biomarker Detection
Published on: February 1, 2022
10:23Synthesis and Functionalization of 3D Nano-graphene Materials: Graphene Aerogels and Graphene Macro Assemblies
Published on: November 5, 2015
Related Concept Videos
Bulk Modulus
Facilitated Transport
Bulk Density of Aggregate
Most natural mineral aggregates, like sand and gravel,...
Primary Active Transport
Secondary Active Transport
Regulated mRNA Transport