Related Experiment Video
Updated: Feb 13, 2026

High-pressure, High-temperature Deformation Experiment Using the New Generation Griggs-type Apparatus
Published on: April 3, 2018
Elimination of Aesthetic Deformations of the Midface Area Our Experience
Marlen Sulamanidze1,2, George Sulamanidze1,2, Constantin Sulamanidze3,4
1Limited Liability Clinic Total Charm and APTOS Company, Moscow, Russia.
Introduction:
The aesthetic manifestations of the aging process in the cheekbone, cheek and infraorbital areas are especially concerning for patients, so rejuvenating interventions in these areas are most in demand.
Objective:
To introduce the experience of our clinic for aesthetic manipulation using Aptos (anti-ptosis) thread lifting methods in the midface area.
Methods:
Among the surgical interventions that we used were Aptos thread lifting methods both in combination with lower blepharoplasty, and without it. At the same time, special attention was paid to the individual approach, trying to minimize invasiveness and, most importantly, trying to achieve the effect of moving subcutaneous soft tissues to a new, more advantageous position from an aesthetic point of view, with their fixation to dense structures.
Results:
The results of application of the presented methods to lift the cheek-zygomatic and infraorbital regions using Aptos methods were studied. In the overwhelming majority of cases, the results satisfied both surgeons and patients.
Conclusions:
Aptos methods for lifting the midface soft tissues, which we used, are quite effective for rejuvenating the aging face.
Level Of Evidence Iv:
This journal requires that authors assign a level of evidence to each article. For a full description of these evidence-based medicine ratings, please refer to the Table of Contents or the online Instructions to Authors www.springer.com/00266 .
Related Concept Videos
Plastic Deformations
Plastic Deformations
Temperature Dependent Deformation
Deformations in a Symmetric Member in Bending
When the member is segmented into tiny cubic elements, it is observed that the primary stress...
Deformation of Member under Multiple Loadings
In the case of a member with a variable cross-section, the strain is not constant but depends on the position. The deformation of an...
Deformation in a Circular Shaft

