Increasing power-law range in avalanche amplitude and energy distributions

Víctor Navas-Portella1,2,3, Isabel Serra1, Álvaro Corral1,2,4,5

  • 1Centre de Recerca Matemàtica, Edifici C, Campus Bellaterra, E-08193 Bellaterra, Catalonia, Spain.

Physical Review. E
|March 18, 2018
PubMed

Related Concept Videos

Power System Distribution01:25

Power System Distribution

Power system distribution involves delivering electrical energy from power plants to consumers through a network of transmission and distribution systems. The process begins at power plants, where energy from coal, gas, nuclear, water, and wind is converted into electrical energy. These plants use three-phase generators, typically rated between 50 to 1300 MVA, with terminal voltages ranging from a few kV to 20 kV, depending on the size and age of the units.
The transmission system is designed...
1.1K
Variation: Normal Distribution, Range, and Standard Deviation02:32

Variation: Normal Distribution, Range, and Standard Deviation

In the field of psychology, there are several ways to organize measurements of a trait, feature, or characteristic (i.e., variables). Qualitative data, such as ethnicity, can be tabulated into a frequency count to provide information about the proportion, as well as the variety of groups in a sample or population. On the other hand, researchers can perform a wider set of calculations on quantitative data. The mean, mode, and median, for instance, are central tendency measures to identify a...
28.7K
Power and Energy01:12

Power and Energy

The power and energy delivered to an element are subjects of great significance in the field of electrical engineering. It is a well-known fact that a 100-watt light bulb emits more light than a 60-watt one. Therefore, power and energy calculations play a crucial role in the analysis of electrical circuits.
Power, defined as the time rate of expending or absorbing energy, is quantified in units called watts (W). The relation between power and energy is mathematically given as
2.1K
Energy and Power Signals01:17

Energy and Power Signals

In an electrical system with a resistor, voltage and current signals facilitate the measurement of power and energy across the resistor. For a continuous-time signal, the total energy over a time interval is defined as the integral of the square of the signal's magnitude over that interval. Mathematically, this is expressed as:
1.2K
Energy and Power of a Wave00:58

Energy and Power of a Wave

The total energy associated with a wavelength is the sum of the potential energy and the kinetic energy. The average rate of energy transfer associated with a wave is called its power, which is total energy divided by the time it takes to transfer the energy. For a sinusoidal wave, energy and power are proportional to the square of both the amplitude and the angular frequency.
Waves can also be concentrated or spread out, as characterized by the intensity of the wave. Intensity is directly...
5.0K
Third Law of Thermodynamics02:38

Third Law of Thermodynamics

A pure, perfectly crystalline solid possessing no kinetic energy (that is, at a temperature of absolute zero, 0 K) may be described by a single microstate, as its purity, perfect crystallinity,and complete lack of motion means there is but one possible location for each identical atom or molecule comprising the crystal (W = 1). According to the Boltzmann equation, the entropy of this system is zero.
22.1K