Strong cooling induced by stand-replacing fires through albedo in Siberian larch forests

Dong Chen1, Tatiana V Loboda2, Tao He3

  • 1Department of Geographical Sciences, University of Maryland, College Park, Maryland, USA. itscd@terpmail.umd.edu.

Scientific Reports
|March 21, 2018
PubMed

Related Concept Videos

Titration Calculations: Strong Acid - Strong Base02:28

Titration Calculations: Strong Acid - Strong Base

Calculating pH for Titration Solutions: Strong Acid/Strong Base
A titration is carried out for 25.00 mL of 0.100 M HCl (strong acid) with 0.100 M of a strong base NaOH. The pH at different volumes of added base solution can be calculated as follows:
(a) Titrant volume = 0 mL. The solution pH is due to the acid ionization of HCl. Because this is a strong acid, the ionization is complete and the hydronium ion molarity is 0.100 M. The pH of the solution is then:
34.1K
Heating and Cooling Curves02:44

Heating and Cooling Curves

When a substance—isolated from its environment—is subjected to heat changes, corresponding changes in temperature and phase of the substance is observed; this is graphically represented by heating and cooling curves.
For instance, the addition of heat raises the temperature of a solid; the amount of heat absorbed depends on the heat capacity of the solid (q = mcsolidΔT). According to thermochemistry, the relation between the amount of heat absorbed or released by a substance, q, and its...
28.1K
Strong Acid and Base Solutions03:22

Strong Acid and Base Solutions

A strong acid is a compound that dissociates completely in an aqueous solution and produces a concentration of hydronium ions equal to the initial concentration of acid. For example, 0.20 M hydrobromic acid will dissociate completely in water and produces 0.20 M of hydronium ions and 0.20 M of bromide ions.
36.1K
Titration of a Strong Acid with a Strong Base01:23

Titration of a Strong Acid with a Strong Base

During the titration of a strong acid with a strong base, pH calculations are primarily based on the concentration of residual hydronium or hydroxide ions. Initially, a strong acid like hydrochloric acid fully dissociates, creating hydronium and chloride ions, resulting in a low pH. The addition of a strong base like sodium hydroxide alters the concentration of hydronium ions by neutralizing them. As more base is added, the pH gradually increases. At the equivalence point, all hydronium ions...
10.6K
Standing Waves01:17

Standing Waves

Sometimes waves do not seem to move; rather, they just vibrate in place. Unmoving waves can be seen on the surface of a glass of milk kept in a refrigerator, which is one example of standing waves. Vibrations from the refrigerator motor create waves on the milk that oscillate up and down but do not seem to move across the surface. These waves are formed or created by the superposition of two or more identical moving waves in opposite directions. The waves move through each other, with their...
5.5K
Modes of Standing Waves - I01:03

Modes of Standing Waves - I

A close look at earthquakes provides evidence for the conditions appropriate for resonance, standing waves, and constructive and destructive interference. A building may vibrate for several seconds with a driving frequency matching the building's natural frequency of vibration; this produces a resonance that results in one building collapsing while the neighboring buildings do not. Often, buildings of a certain height are devastated, while other taller buildings remain intact. This...
4.1K