Flight speed and performance of the wandering albatross with respect to wind

Philip L Richardson1, Ewan D Wakefield2, Richard A Phillips3

  • 11Department of Physical Oceanography, MS#21, Woods Hole Oceanographic Institution, 360 Woods Hole Road, Woods Hole, MA 02543 USA.

Movement Ecology
|March 21, 2018
PubMed
Abstract

Related Concept Videos

Area Between Curves: Integrating With Respect to y01:29

Area Between Curves: Integrating With Respect to y

Consider a planar region bounded by two curves that are both written as functions of the vertical variable, y. The left and right boundary curves are continuous between y = c and y = d, and these two horizontal lines define the vertical limits of the region. Because the boundaries depend on y rather than x, the area is most appropriately evaluated using horizontal slices.The area is obtained using the Riemann sum method. The region is divided into many thin horizontal strips, each having an...
68
Area Between Curves: Integrating With Respect to x01:25

Area Between Curves: Integrating With Respect to x

Consider two continuous functions defined on a closed interval from a to b. The region between these curves is bounded vertically by their graphs and horizontally by the endpoints of the interval. The objective is to measure the area of this region.An initial estimate of the area can be obtained by dividing the interval into a large number of narrow vertical strips of equal width. Each strip is approximated by a rectangle whose height is given by the vertical difference between the two...
137
Three-Winding Transformers01:19

Three-Winding Transformers

Three identical single-phase transformers can be configured to form a three-phase transformer connection, which involves high-voltage and low-voltage windings. The high-voltage windings are denoted by capital letters A-B-C, while the low-voltage windings are labeled with lowercase letters a-b-c, representing their respective phases. This notation helps distinguish between the high and low voltage sides of the transformer.
In the per-unit equivalent circuit of a grounded Y-Y three-phase...
727
Wind Turbine Machine Models01:24

Wind Turbine Machine Models

In the growing field of wind energy, incorporating wind turbine models into transient stability analysis is essential. Induction and synchronous machines are the primary models used, with induction machines being prevalent due to their simplicity and reliability.
Induction machines interact through the rotating magnetic field generated by the stator and the rotor. The key parameter is slip, which is the difference between synchronous speed and rotor speed relative to synchronous speed. Slip is...
613
Speed of Sound in Gases01:08

Speed of Sound in Gases

The speed of sound in a gaseous medium depends on various factors. Since gases constitute molecules that are free to move, they are highly compressible. Hence, sound waves travel slowly through gases. Thermodynamics helps us understand the relationship between pressure, volume, and temperature of gases, thus, the speed of sound in an ideal gas can be determined using the laws of thermodynamics. At the same time, Newton's laws of motion and the continuity equation of fluid dynamics also come...
4.1K
Speed of a Transverse Wave01:13

Speed of a Transverse Wave

The speed of a wave depends on the characteristics of the medium. For example, in the case of a guitar, the strings vibrate to produce the sound. The speed of the waves on the strings and the wavelength determine the frequency of the sound produced. The strings on a guitar have different thicknesses but may be made of similar material. They have different linear densities, and the linear density is defined as the mass per length.
One of the key properties of any wave is the wave speed. Light...
4.0K