Related Experiment Video
Updated: Feb 12, 2026

Operating Procedures of the Electrochemotherapy for Treatment of Tumor in Dogs and Cats
Published on: October 24, 2016
Updated standard operating procedures for electrochemotherapy of cutaneous tumours and skin metastases
Julie Gehl1,2,3, Gregor Sersa4, Louise Wichmann Matthiessen3
1a Center for Experimental Drug and Gene Electrotransfer (C*EDGE), Department of Clinical Oncology and Palliative Care , Zealand University Hospital , Roskilde , Denmark.
Abstract:
Electrochemotherapy is now in routine clinical use to treat cutaneous metastases of any histology, and is listed in national and international guidelines for cutaneous metastases and primary skin cancer. Electrochemotherapy is used by dermatologists, surgeons, and oncologists, and for different degrees and manifestations of metastases to skin and primary skin tumours not amenable to surgery. This treatment utilises electric pulses to permeabilize cell membranes in tumours, thus allowing a dramatic increase of the cytotoxicity of anti-cancer agents. Response rates, often after only one treatment, are very high across all tumour types. The most frequent indications are cutaneous metastases from malignant melanoma and breast cancer. In 2006, standard operating procedures (SOPs) were written for this novel technology, greatly facilitating introduction and dissemination of the therapy. Since then considerable experience has been obtained treating a wider range of tumour histologies and increasing size of tumours which was not originally thought possible. A pan-European expert panel drawn from a range of disciplines from dermatology, general surgery, head and neck surgery, plastic surgery, and oncology met to form a consensus opinion to update the SOPs based on the experience obtained. This paper contains these updated recommendations for indications for electrochemotherapy, pre-treatment information and evaluation, treatment choices, as well as follow-up.
Related Concept Videos
Standard Electrode Potentials
Real Number Operations
Operational Amplifiers
Standard Enthalpy of Formation
Vector Operations
A vector multiplied by a scalar value is called scalar multiplication. The result obtained is a new vector with a different magnitude. If the scalar is positive, the direction of the vector remains the same, but if it is negative, the direction of the vector is reversed. For example, the product of the mass and velocity yields the momentum.
Operant Conditioning
Reinforcement in operant conditioning can be positive or negative, both of which serve to increase the likelihood of a behavior. Positive...

