Related Experiment Video
Updated: Feb 12, 2026

Silicon Metal-oxide-semiconductor Quantum Dots for Single-electron Pumping
Published on: June 3, 2015
Directly modulated 1.3 μm quantum dot lasers epitaxially grown on silicon
Abstract:
We report the first demonstration of direct modulation of InAs/GaAs quantum dot (QD) lasers grown on on-axis (001) Si substrate. A low threading dislocation density GaAs buffer layer enables us to grow a high quality 5-layered QD active region on on-axis Si substrate. The active layer has p-modulation doped GaAs barrier layers with a hole concentration of 5 × 1017 cm-3to suppress gain saturation. Small-signal measurement on a 3 × 580 μm2 Fabry-Perot laser showed a 3dB bandwidth of 6.5 GHz at a bias current of 116 mA. A 12.5 Gbit/s non-return-to-zero signal modulation was achieved by directly probing the chip. Open eyes with an extinction ration of 3.3dB was observed at room temperature. The bit-error-rate (BER) curve showed no error-floor up to BER of 1 × 10-13. 12 km single-mode fiber transmission experiments using the QD laser on Si showed a low power penalty of 1 dB at 5Gbit/s. These results demonstrate the potential for QD lasers epitaxially grown on Si to be used as a low-cost light source for optical communication systems.
Related Concept Videos
Quantum Numbers
The Quantum-Mechanical Model of an Atom
The Dot Product
Dot Product
In engineering, the dot product of any two vectors is the product of the magnitudes of the vectors and the cosine of the angle between them. It is denoted by a dot symbol between the two vectors.
Consider a vehicle pulling an object along the ground using a rope. If the rope makes an angle with the horizontal axis, the work done can be calculated using the dot product of the force applied and the object's displacement.
The dot...
Dot Product: Problem Solving
Identify the problem: Start by reading the problem and...
Scalar Product (Dot Product)
The scalar product of two vectors is obtained by multiplying...

