Related Experiment Video
Updated: Feb 12, 2026

Ballistic Labeling of Pyramidal Neurons in Brain Slices and in Primary Cell Culture
Published on: April 2, 2020
Is the renal pyramidal thickness a good predictor for pyeloplasty in postnatal hydronephrosis?
Amr Hodhod1, John-Paul Capolicchio2, Roman Jednak2
1Department of Pediatric Surgery, Montreal Children's Hospital, McGill University, Montreal, Quebec, Canada; Department of Urology, Faculty of Medicine, Menoufia University, Al Minufya, Egypt.
Objectives:
We evaluated the feasibility and value of renal pyramidal thickness (PT) as a predictor of pyeloplasty in high-grade postnatal hydronephrosis.
Patients And Methods:
We retrospectively reviewed the charts of patients who presented with postnatal hydronephrosis from 2008 to 2013. Included cases had grade 3 or 4 hydronephrosis. We included only units diagnosed as ureteropelvic junction obstruction. Gender, laterality, hydronephrosis side, renogram data, and follow-up data were recorded. Two investigators reviewed all patients' ultrasounds images. We measured PT and pelvic anteroposterior diameter (APD) in the last ultrasound before surgery. For those managed conservatively, measurements were obtained from the ultrasound with worst hydronephrosis. PT was measured in supine position in the middle third of the sagittal plane (Figure). We assessed the reliability of PT measurement using the intraclass correlation coefficient (ICC). Univariate and multivariate analyses were used to correlate the collected parameters to pyeloplasty incidence. Receiver operating characteristic curve was used to evaluate the cutoff value of PT that predicts pyeloplasty.
Results:
The total included cases were 155 patients (165 units). One hundred and fourteen units had grade 3 hydronephrosis and 51 units had grade 4 hydronephrosis. Fifty-two cases (55 units) underwent pyeloplasty. The median follow-up period was 37.6 months. PT measurement was reliable (ICC = 0.94). Univariate analysis revealed that SFU grading, APD, PT, T1/2, and MAG-3 curves were associated with surgery. Multivariate analysis showed that PT was a single independent predictor for pyeloplasty. PT ≤ 3 mm had 98.1% sensitivity and 89.7% specificity in predicting pyeloplasty.
Discussion:
PT is the first portion of renal parenchyma that is affected in high-grade hydronephrosis. Moreover, it changes little over the first 9 years of life. PT measurement in hydronephrosis was not previously evaluated. We found that PT was easily measured in most kidneys with high negative predictive value. The PT value as an indicator for pyeloplasty should undergo extensive assessment by other institutions with different protocols.
Conclusion:
Being a slowly growing part of the parenchyma, PT can be a good measurable parameter to predict pyeloplasty. Measurement of PT in hydronephrosis is reliable. PT ≤ 3 mm can predict pyeloplasty with 98.1% sensitivity and 89.7% specificity.
Related Concept Videos
Factors Affecting Renal Clearance: Renal Impairment
One condition associated with renal failure is uremia. Uremia is characterized by impaired glomerular filtration and fluid accumulation in the body. This condition hinders the renal clearance of drugs, resulting in drug accumulation and potential...
Renal Corpuscle
Glomerulus: Structure and Function
The glomerulus is a tiny, intricate network of capillaries located at the beginning of the nephron. It's enveloped by the Bowman's capsule and receives its blood supply from an afferent arteriole, which divides into numerous...
Renal Clearance
Renal clearance refers to the volume of plasma cleared of a specific substance, such as creatinine, per unit of time. To measure clearance, urine samples are collected over a 24-hour period during each bladder voiding, followed by a single blood sample at the...
Renal Drug Clearance: Comparison Between Renal Excretion Methods
Renal clearance is often associated with the renal glomerular filtration rate (GFR), which represents the rate at which plasma is filtered through the glomeruli in the kidney. When drug reabsorption is minimal and there is no active secretion, renal clearance is closely related to the...
Design Example: Deciding Thickness of Lubricating Fluid in a Shaft
To calculate the required thickness of the lubricant layer, the tangential velocity at the shaft's surface must first be determined. This velocity is calculated by converting the rotational speed to angular velocity...
Drug Elimination: Non-Renal Routes

