Related Experiment Video
Updated: Feb 12, 2026
Subconjunctival Administration of Adeno-associated Virus Vectors in Small Animal Models
Published on: March 16, 2022
Freeze-dried matrices for ocular administration of bevacizumab: a comparison between subconjunctival and intravitreal
Susi Burgalassi1, Daniela Monti2, Nadia Nicosia1,3
1Department of Pharmacy, University of Pisa, via Bonanno 33, 56126, Pisa, Italy.
Abstract:
This work was aimed to tune solid matrices for bevacizumab (BVZ) subconjunctival or intravitreal administration in order to prolong drug release, to reduce the number of applications and consequently the side effects. Matrices, with sizes suitable for intravitreal or subconjunctival administration, based on hydroxypropylmethyl cellulose (HPMC), polyvinylpyrrolidone (PVP), polyvinyl alcohol (PVA) and polyacrylic acid (PAA) were obtained by freeze-drying of polymeric dispersions either in phosphate buffer solution or water and were sterilized by gamma rays. The matrices were characterized from the technological point of view and evaluated for in vitro release of dextran and BVZ. In vivo evaluation of BVZ release in ocular humours was finally carried out on rabbits. The obtained matrices showed solvent sorption time ranging from a few seconds for PAA to 46 min for HPMC, with shorter times when prepared in buffer solution. The hydration times were up to 5.5-fold higher after sterilization. HPMC and PVA matrices showed a slowdown of the release rate of both dextran and BVZ, but HPMC was selected for following in vivo studies also in consideration of its higher viscosity after rehydration of the matrix. HPMC matrix was well tolerated by the rabbit eye when intravitreally and subconjunctivally administered. The different treatment produced the same effect in terms of drug concentration in aqueous and vitreous humour up to 12 weeks after administration. The results of this study support the possible use of lyophilized matrices as a BVZ delivery system to the posterior segment of the eye.
Related Concept Videos
01:18Additional Routes of Drug Administration
Administering drugs via inhalation allows for the direct delivery of gaseous, volatile substances or droplets to different parts of the respiratory tract. One of the advantages of the inhalation route is the rapid absorption of drugs into the circulatory system, which is possible because of the large surface area of...
01:18Routes of Drug Administration: Enteral
Enteral administration involves drug administration via the mouth in two ways: orally or sublingually.
Unlike sublingually drugs, drugs that are taken orally pass through the gastrointestinal (GI) tract and get metabolized by the liver. Once metabolized, the drug is absorbed into the systemic circulation, reaching different body parts via the bloodstream. However, while passing through the stomach,...
01:25Routes of Drug Administration: Parenteral
The intravenous route (IV) of drug administration can be further categorized into two types. The bolus injection administers the entire dose rapidly, while an intravenous infusion slowly delivers smaller doses steadily.
The IV route is often...
01:22Routes of Drug Administration: Overview
Enteral administration refers to drugs absorbed through the gastrointestinal tract. They can be swallowed (perorally), placed under the tongue (sublingually), or on the inner lining of the cheeks (buccally). Perorally administered drugs take time to be absorbed and have a slower onset of action. The rectal route is another form of enteral administration, which allows for...
01:12Two-Compartment Open Model: Extravascular Administration
The absorption exponent (ka) indicates the speed at which the drug...
01:26Drug Administration and Therapy Phases: Overview
The pharmaceutical phase focuses on leveraging the physicochemical properties of the drug to design and manufacture an effective product. Variants include orally administered tablets or capsules, topical creams or ointments, and parenteral-delivery solutions or emulsions.
The pharmacokinetic phase...