Passive air sampling of flame retardants and plasticizers in Canadian homes using PDMS, XAD-coated PDMS and PUF...

Passive air samplers (PAS) were evaluated for measuring indoor concentrations of phthalates, novel brominated flame retardants (N-BFRs), polybrominated diphenyl ethers (PBDEs), and organophosphate esters (OPEs). Sampling rates were obtained from a 50-day calibration study for two newly introduced PAS, polydimethylsiloxane (PDMS) or silicone rubber PAS (one with and one without a coating of styrene divinyl benzene co-polymer, XAD) and the commonly used polyurethane foam (PUF) PAS. Average sampling rates normalized to PAS surface area were 1.5 ± 1.1 m³ day^-1 dm^-2 for both unsheltered PDMS and XAD-PDMS, and 0.90 m³ ± 0.6 day^-1dm^-2 for partially sheltered PUF. These values were derived based on the compound-specific sampling rates measured here and in the literature for the PAS tested, to reasonably account for site-specific variability of sampling rates. PDMS and PUF were co-deployed for three weeks in 51 homes located in Ottawa and Toronto, Canada. Duplicate PUF and PDMS samplers gave concentrations within 10% of each other. PDMS and PUF-derived air concentrations were not statistically different for gas-phase compounds. PUF had a higher detection of particle-phase compounds such as some OPEs. Phthalate and OPE air concentrations were ∼100 times higher than those of N-BFRs and PBDEs. Concentrations were not systematically related to PM₁₀, temperature or relative humidity. We conclude that both PAS provide replicable estimates of indoor concentrations of these targeted semi-volatile organic compounds (SVOCs) over a three-week deployment period. However, PUF is advantageous for collecting a wider range of compounds including those in the particle phase.