Sediment accumulation and mixing in the Penobscot River and estuary, Maine

K M Yeager1, K A Schwehr2, K J Schindler1

  • 1Sedimentary and Environmental Radiochemistry Research Laboratory (SER(2)L), Department of Earth and Environmental Sciences, University of Kentucky, Lexington, KY 40506, United States.

Related Concept Videos

Mixing Concrete01:30

Mixing Concrete

Concrete mixing ensures a homogenous blend where aggregates are well-coated with cement paste. Concrete mixing is typically done using two main types of mixers: batch and continuous. Batch mixers handle one batch at a time, thoroughly combining materials before discharging and receiving the next batch. In contrast, continuous mixers receive a steady flow of ingredients, mixing them consistently and discharging without interruption. Within batch mixers, tilting drum mixers mix with internal...
399
Mixing Time01:19

Mixing Time

The concept of mixing time is significant in producing a uniform concrete mix with the required strength. The mixing period starts once all components are in the mixer. Initially, the mixer is charged with 10% of the water, followed by the consistent addition of solids and then 80% of the water. The remaining water is added later, within the first quarter of the mixing period. The minimum mixing time varies according to the mixer's capacity; for example, mixers with up to 1 cubic yard...
486
Ready Mixed Concrete01:26

Ready Mixed Concrete

Ready-mixed concrete, also known as pre-mixed concrete, is prepared in a centralized plant and then transported in trucks to construction sites where it is ready for placement. This type of concrete is categorized into central-mixed, truck-mixed (or transit-mixed), and shrink-mixed. Central-mixed concrete is entirely prepared at a plant and moved to the site in agitator trucks that rotate at a speed of 2 to 6 rpm. Truck-mixed concrete, on the other hand, has the ingredients batched at the plant...
378
Design Example: Vintage Mixing Console01:17

Design Example: Vintage Mixing Console

A sound engineer at a music company recently encountered a problem. The output from their newly acquired studio's vintage mixing console was too low for the requirements of modern recording equipment. To rectify this situation, the engineer decided to design an audio pre-amplifier using an operational amplifier (op-amp) to boost the signal level.
The specifications for the pre-amplifier were clear. It needed to amplify the audio signal by a factor of 10, have an input impedance above 10...
589
Drug Accumulation During Multiple Dosing: Repetitive IV Injections01:21

Drug Accumulation During Multiple Dosing: Repetitive IV Injections

Calculating drug dosage and accumulation in multiple-dose regimens is crucial for achieving therapeutic efficacy while avoiding toxicity. This involves determining the plasma drug concentrations over time to optimize dosing schedules. The principle of superposition is fundamental in this process, allowing for the prediction of drug concentration in plasma following multiple doses based on single-dose data.The principle of superposition asserts that the plasma concentration-time curves from...
290
Drug Accumulation During Multiple Dosing: Intermittent IV Infusions01:24

Drug Accumulation During Multiple Dosing: Intermittent IV Infusions

Intermittent intravenous (IV) infusion is a method of drug administration where medications are delivered over short infusion periods followed by intervals of no drug delivery. This approach helps to prevent sustained high drug concentrations in the bloodstream, reducing the risk of adverse effects associated with prolonged exposure. Unlike continuous infusion, steady-state concentrations may not be achieved during a single dosing cycle but can be reached through repeated...
267