Physical and geometrical parameters controlling measurements of radon emanation and exhalation from soil

A F Saad1, R M Abdallah2, N A Hussein2

  • 1Physics Department, Faculty of Science, University of Benghazi, Benghazi, Libya; Physics Department, Faculty of Science, Zagazig University, 44519 Zagazig, Egypt.

Related Concept Videos

Geometric Mean01:15

Geometric Mean

The mean is a measure of the central tendency of a data set. In some data sets, the data is inherently multiplicative, and the arithmetic mean is not useful. For example, the human population multiplies with time, and so does the credit amount of financial investment, as the interest compounds over successive time intervals.
In cases of multiplicative data, the geometric mean is used for statistical analysis. First, the product of all the elements is taken. Then, if there are n elements in the...
4.1K
Pulmonary Cycle: Exhalation01:17

Pulmonary Cycle: Exhalation

In terms of human respiration, the act of expelling air, known as exhalation (or expiration), operates on the principle of pressure gradients. During expiration, the pressure within the lungs exceeds that of the surrounding atmosphere. Under normal conditions, quiet breathing involves passive exhalation and is free of muscular contractions. This is because the exhalation process is driven by the natural elastic recoil of the lungs and chest wall, both of which have an inherent tendency to...
3.7K
The Soil Ecosystem02:23

The Soil Ecosystem

Plants obtain inorganic minerals and water from the soil, which acts as a natural medium for land plants. The composition and quality of soil depend not only on the chemical constituents but also on the presence of living organisms. In general, soils contain three major components:
25.0K
Geometric Sequences01:30

Geometric Sequences

In systems where values diminish by a constant proportion at each stage, the resulting sequence follows a geometric structure. Each new value in the sequence is obtained by applying a fixed multiplier to the preceding term. This regular, proportional decline type is often used to represent processes involving gradual loss, such as energy dissipation or reduction in amplitude over time.When analyzing the total effect of such a process across unlimited iterations, the series of values is referred...
289
Physical Methods for Controlling Microbial Growth: Temperature01:23

Physical Methods for Controlling Microbial Growth: Temperature

Heat is a widely used method to control microbial growth by targeting and denaturing cellular proteins, thereby killing or inactivating microbes. This method's effectiveness is quantified using parameters such as the thermal death point (TDP), thermal death time (TDT), and decimal reduction time (D value). TDP represents the lowest temperature at which all microorganisms in a liquid suspension are eliminated within 10 minutes, whereas TDT is the time necessary to achieve sterilization at a...
1.2K
Physical Methods for Controlling Microbial Growth: Radiation and Filtration01:26

Physical Methods for Controlling Microbial Growth: Radiation and Filtration

Radiation and filtration are essential tools for microbial control, targeting microorganisms through distinct mechanisms. Radiation eliminates microbes by damaging their DNA, either killing them or inhibiting their growth. Based on wavelength, radiation is classified into two types: nonionizing and ionizing radiation.Non-ionizing radiation, such as UV radiation (200–400 nm), is absorbed by DNA, causing defects that effectively disinfect surfaces, air, and water, including safety cabinets.
1.2K