Related Experiment Video
Updated: Feb 11, 2026

Controlled Cervical Laceration Injury in Mice
Published on: May 9, 2013
Cervical spine injury in rollover crashes: Anthropometry, excursion, roof deformation, and ATD prediction
Carolyn W Roberts1, Jacek Toczyski2, Jason R Kerrigan2
1University of Virginia Center for Applied Biomechanics, 4040 Lewis and Clark Drive, Charlottesville, VA 22911, USA.
Abstract:
While rollover crashes are rare, approximately one third of vehicle occupant fatalities occur in rollover crashes. Most severe-to-fatal injuries resulting from rollover crashes occur in the head or neck region, due to head and neck interaction with the roof during the crash. While many studies have used anthropomorphic test devices (ATDs) to predict head and neck injury, the biofidelity of ATDs in rollover has not been established. This study aims to build on previous research to compare the dynamic response and injuries sustained by four post mortem human surrogates (PMHS) to those predicted by six different ATDs in full-scale rollover crash tests. Additionally, this study evaluates injuries sustained by PMHS relative to possible contributing factors including occupant kinematics, occupant anthropometry, and vehicle roof deformation. While the vehicle kinematics and roof deformation were comparable for all tests, three out of the four PMHS sustained cervical spine injury, but only the tallest specimen sustained cervical spine fracture. Neck flexion at the time of head-to-roof contact appears to have affected cervical spine injury risk in these cases. Despite the injuries sustained in the PMHS, none of the six ATDs measured forces or accelerations that exceeded injury assessment reference values (IARVs), which adds to recent literature illustrating substantial differences between ATDs and PMHS in a rollover-like scenario.
More Related Videos
Related Concept Videos
Plastic Deformations
Plastic Deformations
Predicting Molecular Geometry
Temperature Dependent Deformation
Deformations in a Symmetric Member in Bending
When the member is segmented into tiny cubic elements, it is observed that the primary stress...
Deformation of Member under Multiple Loadings
In the case of a member with a variable cross-section, the strain is not constant but depends on the position. The deformation of an...

